Cisco Catalyst 9400 Series Hardware Installation Manual page 78
Hide thumbs
Also See for Catalyst 9400 Series:
- System management configuration manual (458 pages) ,
- Installation note (32 pages) ,
- Troubleshooting manual (14 pages)
Table of Contents
Advertisement
Rack-Mounting the Chassis in a NEBS-Compliant Mode
• Place the chassis on the floor or on a sturdy table as close as possible to the rack. Leave enough clearance
to allow you to move around the chassis.
• Open the rack-mount kit and verify that all parts are included.
Note
Some equipment racks provide a power strip along the length of one of the rear posts. If your rack has this
feature, consider the position of the strip when planning fastener points. Before installing the brackets on the
chassis, determine whether to install the chassis from the front or the rear of the rack.
Procedure
Step 1
Remove and discard the mounting ears and the ten mounting screws of the chassis. Do not reuse them during
any part of the installation process.
Figure 20: Remove the Mounting Ears
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
72
Installing the Switch
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
