Document # PGCI-008
Cutout Dimensions
All tolerances +1/16" (+1.6 mm), -0, unless otherwise noted.
iMPOrTanT: Be careful to use the correct cutout diagram (on page 2/2) to determine the countertop dimensions. Carefully double check all dimensions
against the table below and the correct diagram before cutting the countertop.
installation Type
RGC/SGM304 with
ERV30[15] or PRV30
RGC/SGM365 with
ERV36[15] or PRV36
RGC/SGM466 with
PRV46
* Total cutout depth, accommodates both the cooktop and raised vent
** iMPOrTanT: Notch depth is included in total cutout depth (D). DO nOT add notch depth to total cutout depth (D).
•
Observe all governing codes and ordinances during
planning and installation. Contact your local building
department for further information.
•
All appliances must be installed in accordance with the
accompanying installation instructions.
All specifications subject to change without notice.
COMBINATION INSTALLATIONS
RGC/SGM Series Drop-In Gas Cooktop
with ERV/PRV Series Raised Vent
Cutout
C (minimum)
Diagram
Figure 1
3/8"
(Square)
(1.0 cm)
Figure 1
3/8"
(Square)
(1.0 cm)
Figure 2
3/8"
(Notched)
(1.0 cm)
warning
Countertop Dimensions
D
E
22 1/2" *
27 3/4"
(57.2 cm)
(68.6 cm)
22 1/2" *
33 5/8"
(57.2 cm)
(85.4 cm)
22 1/2" *
44 3/4"
(57.2 cm)
(113.7 cm)
Stiffener
SIDE VIEw - RGC/SGM SERIES COOkTOP wITh
www.dacor.com
Revised 10/04/12 Page 1/2
PLANNING
F
g
NA
NA
NA
NA
43 1/2"
5/8"
(110.5 cm)
(1.6 cm)
3/8" min. (1.0 cm)
flat countertop overhang
required behind cutout
SGM series cooktop
RGC or SGM series cooktop
Cabinet face
3/8" min. (1.0 cm) space
behind raised vent
chassis to clear stiffener
ERV or PRV series raised
vent: Check raised vent
dimensions/specifications
to determine proper fit
Floor
ERV/PRV SERIES RAISED VENT
Phone: (800) 793-0093
GUIDE
H
NA
NA
2 5/8" **
(6.7 cm)
Countertop