hit counter script
Toro Recycler 20070 Operator's Manual
Toro Recycler 20070 Operator's Manual

Toro Recycler 20070 Operator's Manual

22in lawn mower
Hide thumbs Also See for Recycler 20070:

Advertisement

Quick Links

22in Recycler® Lawn Mower
Model No. 20070—Serial No. 260000001 and Up
Introduction
Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a dealer,
or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model and
serial numbers of your product ready. Figure 1 identifies the
location of the model and serial numbers on the product.
Figure 1
1. Model and serial number plate
Write the product model and serial numbers in the space
below:
Model No.
Serial No.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol (Figure 2),
which signals a hazard that may cause serious injury or
death if you do not follow the recommended precautions.
Figure 2
1. Safety alert symbol
This manual uses two words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
© 2005—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
The engine exhaust from this product contains
chemicals known to the State of California to cause
cancer, birth defects, or other reproductive harm.
Important: This engine is not equipped with a
spark arrester muffler. It is a violation of California
Public Resource Code Section 4442 to use or operate
the engine on any forest-covered, brush-covered, or
grass-covered land. Other states or federal areas may
have similar laws.
This spark ignition system complies with Canadian
ICES-002
The enclosed Engine Owner's Manual is supplied
for information regarding the US Environmental
Protection Agency (EPA) and the California Emission
Control Regulation of emission systems, maintenance,
and warranty. Replacements may be ordered through
the engine manufacturer.
For models with stated engine horsepower, the gross
horsepower of the engine was laboratory rated by the engine
manufacturer in accordance with SAE J1940. As configured
to meet safety, emission, and operating requirements, the
actual engine horsepower on this class of lawn mower will
be significantly lower.
Safety
This lawn mower meets or exceeds the CPSC blade safety
requirements for walk-behind rotary lawn mowers and the
B71.1 specifications of the American National Standards
Institute in effect at the time of production.
Read and understand the contents of this manual
before you start the engine.
The safety alert symbol (Figure 2) is used to alert you to
potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
Improperly using or maintaining this mower could result in
injury or death. To reduce this potential, comply with the
following safety instructions.
Register at www.Toro.com.
Form No. 3354-915 Rev A
Operator's Manual
Warning
CALIFORNIA
Proposition 65 Warning
Original Instructions (EN)
Printed in the USA.
All Rights Reserved

Advertisement

Table of Contents
loading

Summary of Contents for Toro Recycler 20070

  • Page 1 Other states or federal areas may additional information, contact an Authorized Service have similar laws. Dealer or Toro Customer Service and have the model and serial numbers of your product ready. Figure 1 identifies the This spark ignition system complies with Canadian location of the model and serial numbers on the product.
  • Page 2: General Operation

    Slope Operation The following instructions have been adapted from the ANSI/OPEI standard B71.1-2003. Slopes are a major factor related to slip and fall accidents, This cutting machine can amputate hands and feet and which can result in severe injury. Operation on all slopes throw objects.
  • Page 3: Safety And Instructional Decals

    Safety and Instructional Decals then refuel such equipment with a portable container, rather than from a gasoline dispenser nozzle. Important: Safety and instruction decals are located • Keep the nozzle in contact with the rim of the fuel near areas of potential danger. Replace damaged tank or container opening at all times until fueling is decals.
  • Page 4 104-7953 1. Warning—read the Operator’s Manual for information on charging the battery; contains lead; do not discard. 2. Read the Operator’s Manual. 105-1295 105-6838 108-4791...
  • Page 5: Unfolding The Handle

    Setup Important: Remove and discard the protective plastic sheet that covers the engine. 1. Unfolding the Handle Folding or unfolding the handle improperly can Figure 5 damage the cables, causing an unsafe operating 2. Filling the Engine with Oil condition. •...
  • Page 6: Installing The Fuse

    Product Overview 3. Installing the Fuse Your mower comes with a 40-amp fuse that protects the electric starter. Important: You cannot start the mower with the electric starter or charge the battery unless you install the fuse. 1. Unclip both ends of the battery cover and remove it (Figure 7).
  • Page 7: Operation

    Operation Checking the Engine Oil Level 1. Remove the dipstick, wipe it clean, and fully install the dipstick (Figure 12). Filling the Fuel Tank Gasoline is extremely flammable and explosive. A fire or explosion from gasoline can burn you and others.
  • Page 8: Adjusting The Cutting Height

    Adjusting the Cutting Height Adjusting the cutting height may bring you into contact with the moving blade, causing serious injury. • Stop the engine and wait for all moving parts to stop. • Do not put your fingers under the housing when adjusting the cutting height. If the engine has been running, the muffler will be hot and can severely burn you.
  • Page 9: Stopping The Engine

    Check the grass bag frequently. If it is damaged, install a new Toro replacement bag.
  • Page 10: Side-Discharging The Clippings

    Side-discharging the Clippings If the side discharge chute is on the mower, remove it and lock the side discharge door (refer to Removing the Side Use the side discharge for cutting very tall grass. Discharge Chute) before bagging the clippings. If the bag is on the mower, remove it and insert the rear discharge plug (refer to Removing the Grass Bag) before side-discharging the clippings.
  • Page 11: Operating Tips

    • For best performance, install a new blade before the cutting season begins. • Replace the blade when necessary with a Toro replacement blade. Cutting Grass • Cut only about a third of the grass blade at a time. Do...
  • Page 12: Recommended Maintenance Schedule(S)

    Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval After the rst 2 operating • Change the engine oil. hours • Check the engine oil level. •...
  • Page 13: Changing The Engine Oil

    Changing the Engine Oil Charging the Battery Change the engine oil after the first 2 operating hours; change it yearly thereafter. Battery posts, terminals, and related accessories Run the engine a few minutes before changing the oil contain lead and lead compounds, chemicals to warm it.
  • Page 14: Replacing The Blade

    Replacing the Blade Important: A bolt torqued to 60 ft-lb (82 N⋅m) is very tight. While holding the blade with a block Important: You will need a torque wrench to install of wood, put your weight behind the ratchet or the blade properly.
  • Page 15: Removing The Mower From Storage

    1. On the last refueling of the year, add fuel stabilizer to 2. Fold the upper handle forward as shown in Figure 39. the fuel as directed by the engine manufacturer. Important: Route the cables to the outside of the 2.
  • Page 16 Instructions for Obtaining Warranty Service If you think that your Toro Product contains a defect in materials or workmanship, or if a normal, able-bodied adult can no longer start your product’s engine in one or two pulls, follow this procedure: Contact any Authorized Toro Service Dealer to arrange service at their dealership.

Table of Contents