Page 1
Washing Machine User Manual WTIK74111 Document Number : 2820528603_EN/ 25-06-20.(14:50)
Page 2
Please read these instructions first before using your appliance Dear Customer, Thank you for choosing a Beko appliance. Please take some time to read this user manual before using your appliance, to ensure you know how to safely operate the controls and functions.
Page 3
1 General safety instructions • While there is still water inside the product, never open the This section includes security loading door or remove the filter. instructions which may help prevent Otherwise, risk of flooding and the injuries and material damage risks. injury from hot water will occur.
Page 4
1.3 Children’s safety CAUTION! • Do not forget to close the CAUTION! loading door when leaving the • This product can be used room where the product is by children at and above 8 located. years old and by persons •...
Page 5
This product has been manufactured with high DANGER quality parts and materials which can be reused and are suitable for recycling. Do not dispose • Do not wash the product by of the waste product with normal domestic spraying or pouring water onto and other wastes at the end of its service life.
Page 6
4 Technical specifications Supplier name or trademark Beko WTIK74111 Model name 7178484600 Rated capacity (kg) Maximum spin speed (rpm) 1400 Built-in Height (cm) Width (cm) Depth (cm) Single Water inlet / Double Water inlet • / - • Available Electrical input (V/Hz)
Page 7
4.1 Installation 4.1.3 Removing the transportation locks • Apply to the nearest authorised service agent for the installation of your product. 1 Loosen all bolts with an appropriate wrench until they turn freely. • Preparation of the location and electrical, tap water and waste water installations at 2 Remove the transport safety bolts by the place of installation is under customer's...
Page 8
• In case the drain hose is elevated after laying it on the floor level or close to the ground (less than 40 cm above the ground), water discharge becomes more difficult and the laundry may come out excessively wet. Therefore, follow the heights described in the figure.
Page 9
Adjusting the feet with water level • The voltage specified in the “Technical specifications” section must be equal to your mains voltage. • Do not make connections via extension cables or multi-plugs. CAUTION! • Damaged power cables must be replaced by the Authorised Service Agents.
Page 10
4.1.8 Initial use Important Fitting a different plug Before starting to use the product make sure that As the colours of the the preparations wires in the mains are made which lead of this appliance are in line with the may not correspond “Important Safety with the coloured...
Page 11
4.2 Preparation 4.2.3 Tips for energy and water saving Following information will help you use the 4.2.1 Sorting the laundry product in an ecological and energy/water- • Sort laundry according to type of fabric, efficient manner. colour, and degree of soiling and allowable •...
Page 12
4.2.6 Using detergent and softener The detergent drawer compartments are indicated below: Choosing the detergent type 1) Left compartment with number “II” (Main Detergent type to be used depends on the wash compartment for powder detergent or washing programme, fabric type and color. powder bleach/stain remover) •...
Page 13
Starch Do not fill the detergent above the maximum filling level line; otherwise the excess amount of • Add liquid starch, powder starch or the detergent will reach the laundry without water dyestuff into the softener compartment as and may cause stains on the garments.In this instructed on the package.
Page 14
4.2.7 Tips for efficient washing Clothes Delicates/ Light colours and whites Colours Dark colours Woolens/Silks (Recommended (Recommended (Recommended temperature (Recommended temperature temperature range temperature range range based on soiling level: range based on soiling level: based on soiling level: based on soiling level: 40-90ºC) cold-40ºC) cold-40ºC)
4.3 Operating the product 1 - Programme Selection Knob (Uppermost position On / Off) 4.3.1 Control panel 2 - Display 3 - End Time Adjustment Button 4 - Programme Follow-up Indicator 5 - Start/Pause Button 6 - Auxiliary Function Button 3 7 - Auxiliary Function Button 2 8 - Auxiliary Function Button 1 9 - Spin Speed Adjustment Button...
Page 16
• : Selectable * : Automatically selected, cannot be cancelled. ** : Eco 40-60 ( ) is the test programme in accordance with EN 60456:2016 and energy label with Commission Delegated Regulation (EU) 1061/2010) ***: Eco 40-60 with 40 °C temperature selection is the test programme in accordance with EN 60456:2016/prA:2019 and energy label with Commission Delegated Regulation (EU) 2019/2014 - : See the programme description for maximum load.
4.3.5 Main programmes • Anti Allergy Depending on the type of fabric, use the Use this programme for laundry that requires following main programmes. an intense, long, anti-allergic and hygienic washing cycle at high temperature. A high • Cottons level of hygiene is ensured thanks to the long You can wash your durable cotton laundry heating and additional rinsing step.
Mixed Fabrics • When the quick function is selected: You can use this programme to wash cottons and Blood Fruit juice synthetics together without the need to sort them. Chocolate Ketchup Pudding Red Wine Curry Shirts • Use this programme to wash shirts made of Coffee Coal cotton, synthetic and synthetic blended fabrics...
Page 19
If you only want to drain the water without If you want to spin the laundry held in water, adjust spinning the laundry, select the “Spin+Pump the Spin Speed and press Start/Pause button. programme, and use the Spin Speed Programme will resume. Water will be drained, Adjustment button to select the No Spin laundry will be spun and the programme will end.
• Extra Rinse INFORMATION This function enables the machine to carry out another rinsing cycle in addition to the • If the Programme Selection knob is turned one carried out after the main wash. Thus, the when the Child Lock is enabled, "Con" risk for sensitive skins (babies, allergic skins, appears on the display.
Changing the delayed end time • AntiCrease+ If you want to change the time during countdown: If you press and hold the auxiliary function button Turn the programme selection knob to cancel the 3 for 3 seconds, this function will be selected delayed end time function, and then set the desired and the programme follow-up light of the relevant time again.
Page 22
You can change the auxiliary functions, speed and temperature settings without stopping the programme flow while the programme is running. To do this, the change you are going to make must be something that will be carried out after the programme step that is running. If the change is not suitable, relevant lights will flash 3 times.
Page 23
Adding and removing laundry 4.3.17 End of programme At the end of the programme, “End” will be 1. Press the “Start/Pause” button to pause the displayed. machine. The programme follow-up light of the relevant step during which the machine 1. Wait until the light of the loading door goes was switched into the pause mode will flash.
Page 24
4.4 Maintenance and cleaning After every washing make sure that no foreign Service life of the product extends and substance is left in the frequently faced problems decrease if cleaned drum. at regular intervals. 4.4.1 Cleaning the detergent drawer If the holes on the bellow shown in the figure is Remove any powder residue buildup in the blocked, open the holes using a toothpick.
Page 25
2. Remove the nuts of the water intake hoses 2. Some of our products have emergency to access the filters on the water intake draining hose and some does not have. valves. Clean them with an appropriate Follow the steps below to discharge the brush.
Page 26
5 Troubleshooting Loading door cannot be opened. • Loading door lock is activated because of the water level in Programmes do not start after the loading door is the product. >>>Drain the water by running the Pump or closed. Spin programme. •...
Page 27
Washing performance is poor: Laundry turns gray. (**) Washing machine does not rinse well. • Insufficient amount of detergent has been used over a long • The amount, brand and storage conditions of the detergent period of time. >>>Use the recommended amount of used are inappropriate.
Page 28
Too much foam forms inside the product. (**) • Improper detergents for the washing machine is used. >>>Use detergents appropriate for the washing machine. • Excessive amount of detergent is used. >>>Use only sufficient amount of detergent. • Detergent was stored under improper conditions. >>>Store detergent in a closed and dry location.
Page 29
BUILT-IN INSTALLATION GUIDE 6 BUILT-IN INSTALLATION 820 mm 153 mm 29 / EN Washing Machine / User’s Manual...
Page 30
30 / EN Washing Machine / User’s Manual...
Page 31
31 / EN Washing Machine / User’s Manual...
Page 32
32 / EN Washing Machine / User’s Manual...
Page 33
IF THE CABINET DOOR OPENS TO RIGHT IF THE CABINET DOOR OPENS TO LEFT 33 / EN Washing Machine / User’s Manual...
Page 34
34 / EN Washing Machine / User’s Manual...
Page 35
35 / EN Washing Machine / User’s Manual...
Page 36
36 / EN Washing Machine / User’s Manual...
Page 37
Service Ref. No. Service Ref. No. 1493 1493 37 / EN Washing Machine / User’s Manual...
Page 38
38 / EN Washing Machine / User’s Manual...
Page 39
If you have purchased an American style Fridge freezer, the standard guarantee starts from the date of original purchase of the product, and lasts for a period of twenty four (24) months unless Beko plc (the “Manufacturer”) agrees to extend the guarantee for the product in writing.
Page 40
If you are resident in the Republic of Ireland, this guarantee will be governed by Irish law and the Irish courts will have jurisdiction. This guarantee is provided by Beko plc. Beko House, 1 Greenhill Crescent, Watford, Hertfordshire. WD18 8QU. Beko plc is registered in England and Wales with company registration number 02415578.
Page 41
Beko Free standing appliances come with a 12 month parts and labour guarantee as standard, Beko Built-in appliances come with a 12 month parts and labour guarantee as standard. This is extended to 24 months, free of charge, upon registration of the appliance. When you register your appliance for additional guarantee, you will automatically activate the ProSmart Motor 10 year guarantee.
Page 42
Send us a secure message through our online contact us form. Please visit our website, click Contact Us and choose a product support topic from the list of options. Complete the required details and click send message. Product registrations For UK registrations please visit beko.co.uk/register and for the Republic of Ireland visit beko.ie/register.