Page 1
OWNER’S MANUAL FREE STANDING GAS COOKER Please read this manual carefully before operating your set and retain it for future reference. LF98105SB LF98110SB www.lg.com P/No.: MFL62060318...
Contents Introduction ................. 3 1. Instructions for safe and proper use ........3 Instructions for the installer ............6 2. Installation of the appliance ............6 3. Adaptation to different types of gas ........12 4. Final operations ..............15 Instructions for the user ............17 5.
Introduction 1. Instructions for safe and proper use This manual is an integral part of the appliance and therefore must be kept in its entirety and in an accessible place for the whole working life of the cooker. We advise reading this manual and all the instructions therein before using the cooker.
Page 4
Introduction DO NOT MODIFY THIS APPLIANCE When not in use, make sure that the control knobs are in the correct (OFF) position ●. Never put inflammable objects in the oven: They could be accidentally catch fire and burn. The I.D plate with technical date, serial number and brand name is positioned visibly in the storage compartment.
Page 5
Do not apply decorative panels to the lower part of the cooker as they may prevent correct air circulation and cause overheating. Before the appliance is put into operation, all the labels and protective films applied inside or outside must be removed. Lower the glass cover slowly and by hand.
Instructions for the installer 2. Installation of the appliance The appliance must be installed by a qualified technician and according to the regulations in force. This appliance may be installed next to a wall which is higher than the appliance, with a minimum distance of 50 mm from the side of the appliance, as shown in drawings A and B showing the correct installation conditions.
Page 7
2.1 Electrical connection Make sure that the power line voltage matches the specifications indicated on the rating plate located inside the storage compartment. This rating plate must never be removed. If the appliance is hooked-up to the supply by means of a fixed connection, install a multipolar cut-out device on the line, with contact opening distance equal to or greater than 3 mm, located near the appliance and in an easily reachable position.
Page 8
Instructions for the installer 2.2 Ventilation requirements 2.2.1 Room ventilation The room containing the appliance should have an air supply in accordance with the standards in force. The room where the appliance is installed must have enough air flow as required for the regular combustion of gas and by the necessary air exchange of the same room.
Page 9
The connector must be screwed so that it remains vertical as shown in the adjacent figure. 2.3.2 Connection with a rubber hose Installation of the standards-compliant rubber hose must be carried out so that the hose length is no greater than 1.5 metres. Make sure that the hose does not come into contact with moving parts or is squashed.
Page 10
Instructions for the installer 2.3.3 Connection to liquid gas Both the pressure regulator and the connection to the cylinder must be standards-compliant. Make the connection to the gas mains using a rubber hose whose specifications comply with the current regulations (verify that the reference standard is stamped on the hose).
Page 11
2.3.5 Connection with a flexible steel hose (for all types of gas) This type of connection can be made on both built-in and free- standing appliances. Only use standards-compliant steel hoses whose length is not greater than 2 metres. After having installed the connector as indicated in “2.4.1 Connector installation”, screw the end of the flexible hose to the threaded external gas connector (ISO 228-1), placing the seal in between.
Instructions for the installer 3. Adaptation to different types of gas Before performing any cleaning or maintenance work, detach the appliance from the electrical socket. The cooker hob is set for LPG G30/G31 at a pressure of 28-37 mbar for cookers with maxi oven In the case of functioning with other types of gas the burner nozzles must be changed and the minimum flame adjusted on the gas taps.
Page 14
Instructions for the installer 3.3 Arrangement of the burners on the hob BURNERS 1. Auxiliary 2. Semi rapid 3. Rapid 4. Triple crown 3.4 Adjustment of the oven burner To adjust the oven burners follow the procedure described below from inside the oven: •...
4. Final operations After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the grids. Following adjustment to a gas other than the preset one, replace the gas adjustment label fixed to the appliance with the one corresponding to the new gas.
Page 16
Instructions for the installer 2. For LPG turn the by-pass screw clockwise as far as it will go. 3. For natural gas, regulate the by-pass so that turning the thermostat knob from minimum to maximum the flame remains stable and constant.
Instructions for the user 5. Description of controls 5.1 Front control panel All the cooker controls and commands are on the front panel. DESCRIPTION OF SYMBOLS Gas oven thermostat Front right burner knob Back right burner Gas Grill Knob Back lefte burner Oven light / Rotisserie Front lefte burner Oven light switch...
Page 18
Instructions for the user GAS GRILL KNOB This knob is used to ignite the grill gas burner inside the oven. The flame is lit by turning the knob anticlockwise to the minimum flame setting, while simultaneously pressing the burner ignition button. In the models not equipped with the burner ignition button to light the burner just press and turn the knob.
6. Use of the hob 6.1 Lighting of the hob burners Before lighting the hob burners check that the flame caps are in the correct position and that their burner caps are in place, making sure that the holes A in the flame caps correspond to the spark plugs and thermocouples.
Page 20
Instructions for the user 6.2 Practical advice for using the hob burners For better use of the burners and lower gas consumption, use covered vessel that are proportional in size to the burner to prevent the flame from heating the sides (see paragraph “6.3 Diameter of the vessels to be used on each burner”).
7. Use of the oven 7.1 Warnings and general advice Using the oven and the grill for the first time, heat them to the maximum temperature for as long as it takes to burn off any production oil residues which could give a nasty flavour to the food. After a power cut, the oven display will flash intermittently and show .
Page 22
Instructions for the user 7.2 Use of the gas oven 7.2.1 Electronic spark lighting Open the oven door completely, press the thermostat knob and turn it anticlockwise to max. temperature. The electronic spark lighting device will be enabled automatically. Once the oven is lit, 200 225 250 hold the knob down for a few seconds to allow the thermocouple to heat up.
Page 23
7.3 Use of the gas grill While using the oven burner at the same time as the grill, turn on the latter at least 10-15 minutes after the oven. 7.3.1 Manual lighting of the gas grill burner Having opened the oven door, press the knob and turn it antoclockwise to the grill MIN position.
Page 24
Instructions for the user 7.4 Use of the rotisserie 7.4.1 Using the rotisserie in cookers with maxi oven Fit the supporting frame onto the second runner up from the bottom so that the seat to take the rod projects outside the oven. Place the rod as shown in the diagram (1) and push the frame into the oven until the end of the rod reaches the hole in the...
Page 25
FOOD GRILLE ON THE SHELF Flat or thin meat Rolled roast joints 2 – 3 Poultry 2 – 3 • Cooking procedures in this mode must never last more than 60 minutes. • In models with gas oven, the door must be half-open on the first catch during grilling and grill-rotisserie cooking.
Instructions for the user 8. Digital timer (certain models only) This component allows an on-off beeper to be set to indicate the end of the cooking time. It is therefore just a timer, with no programming functions. LIST OF FUNCTIONS TIME-SETTING BUTTON VALUE DECREASE BUTTON VALUE INCREASE BUTTON...
8.3 Deactivating the acoustic device The acoustic device stops sounding automatically after seven minutes. It can be deactivated in manual mode by pressing the key. 8.4 Adjusting the volume of the acoustic device The volume can be adjusted (3 settings) while it is in operation by pressing the key.
Instructions for the user 10. Available accessories The oven has 4 support for positioning plates and racks at various heights. Oven grill: for cooking food on plates, small cakes, roasts or food requiring light grilling. Plate grill: for placing above plate for cooking foods that might drip.
11. Cleaning and maintenance 11.1 Cleaning stainless steel and enamelled versions To maintain stainless steel in good condition clean it regularly after each use, once it has cooled down. 11.1.1 Ordinary daily cleaning To clean and preserve the stainless steel surfaces, always use only specific products that do not contain abrasives or chlorine-based acids.
Page 30
Instructions for the user 11.2.2 Grids Remove the grids and clean them in warm water with a non- abrasive detergent, taking care to remove any incrustations. Replace them on the cooking hob. Continuous contact of the grids with the flame can cause the paint near the hot areas to be altered.
Page 31
11.3 Cleaning of oven For best oven upkeep clean regularly after having allowed to cool. Take out all removable parts. • Clean the oven grill with hot water and non-abrasive detergent. Rinse and dry. • Do not allow residues of sugary foods (such as jam) to set inside the oven.
Instructions for the user 12. Extraordinary maintenance The oven may require extraordinary maintenance or replacement of parts subject to wear such as seals, bulbs, and so on. The following instructions describe how to carry out these minor maintenance operations. Before any intervention, disconnect the power supply of the device.