Page 3
Please read this user manual first! Dear Customer, We hope that you get the best results from your product which has been manufactured with high quality and state-of-the-art technology. Therefore, please read this entire user manual and all other accompanying documents carefully before using the product and keep it as a reference for future use.
InstructIons for safety and envIronment This section contains safety electric shock! instructions that will help to Never touch the plug with • give protection from risk of wet hands! Never unplug by personal injury or property pulling on the cable, always damage.
InstructIons for safety and envIronment It must be used to do the Store all detergents and • • domestic type dishes only. additives in a safe place This appliance is intended away from the reach of the • to be used in household and children.
InstructIons for safety and envIronment Compliance with WEEE collection points designated by the local authorities. Directive and Disposing of the Waste Product This product complies with EU WEEE Directive (2012/19/EU). This product bears a classification symbol for waste electrical and electronic equipment (WEEE).
Dishwasher Technical specifications Compliance to standards and test data / EC declaration of conformity This product complies with the following EU directives; Development, production and sales stages of this product comply with the safety rules included in all pertaining European Community regulations. 2006/95/EC, 2004/108/EC, 93/68/EC, IEC 60436/DIN 44990, EN 50242 Power input 220-240 V, 50 Hz (see rating label)
Installation To make the product ready for use, Do not install the product at places • make sure that the electricity, tap water where temperature may fall below supply and water drainage systems are 0ºC. appropriate before calling the Authorised Place the product on a rigid floor.
Installation must be min. 50 cm and max. 100 cm from We recommend that this appliance be the floor. A discharge hose longer than 4 connected to the mains supply via a meters will cause washing performance suitable switched and fused socket in a to be affected.Attach the water discharge readily accessible position.
Installation with the coloured markings identifying the Before using the product, fill the salt • terminals on your plug, proceed as follows: reservoir with 1 litre of water, add salt (see next page) and stir to dissolve. Connect the green - yellow or green Run the Dishwasher without dishes (earth) wire to the terminal in the plug on a short programme with a small...
Preparation Tips for energy saving operates with the same performance continuously. Dishwasher salt is used for Following information will help you use the this purpose. product in an ecological and energy-efficient Use only special softening salts manner. produced particularly for the Wipe away any coarse food remnants on dishwashers in your machine.
Preparation 2. Turn the salt reservoir lid counter 4. Replace the lid and tighten it securely clockwise to open it (A, B). when the reservoir is full. 5. If you will not start a washing programme Salt reservoir will fill with water immediately after adding the salt, run the when you start the product.
Page 15
Preparation Test Strip 1 second Level 1 No Lime Level 2 Very low lime content Level 3 Low lime content Level 4 Medium lime content 1 minute Level 5 High lime content Very High lime content Level 6 Remove the Let the water Take the test strip Hold for...
Preparation Put the detergent into the detergent If you move your house, it dispenser just before operating the is very important to make machine as illustrated below. the water hardness level Push the latch to right to open the adjustment of your machine detergent dispenser lid (A).
Preparation If dishes have been waiting Tablet detergents give for a long time and have satisfying results only under dried residues, fill the 5 cm³ certain usage conditions. The compartment too (5). best washing performance in dishwashers is obtained 3. Close the detergent dispenser lid by by using detergent, rinse pressing on it lightly.
Preparation 4. Make the appropriate rinse aid Wipe clean any spilled rinse aid settings. outside the reservoir. Rinse aid that spilled accidentally Depending on the model, will cause foaming and it will salt indicator and/or rinse aid eventually decrease washing indicator must be enabled again performance.
Page 19
Preparation Decorative prints of chinaware To prevent possible injuries, as well as aluminum and silver always place the sharp and items may get discoloured pointed dishes such as service or tarnished after washing fork, bread knife, etc. upside in the dishwasher just as it down so as their pointed ends happens in handwashing as will face down or they will lie...
Page 20
Preparation Suggestions for loading the dishwasher Improper Loading Of Dishware Lower basket Upper basket Improper Loading Of Dishware 19 / 39 EN Dishwasher / User’s Manual...
Preparation Adjusting the height of the upper basket Basket adjustment mechanism on the loaded upper basket of the machine is designed to allow you create taller areas in the upper or lower section of the machine based on your requirements by adjusting the height of the loaded basket in up or down directions.
Preparation Collapsible upper basket Cutlery basket tines Cutlery basket is designed to wash your dishes such as knife, fork, spoon, etc. in an There are foldable tines on the upper efficient manner. basket of the machine that you can lay Since the cutlery basket can be moved (A, down when you need larger space for big B), you can create more space while placing...
Preparation Collapsible lower basket Bringing the tines to the horizontal position by holding tines them from the tips may cause The six piece foldable tines (A) located them to bend. Therefore, it at the lower basket of the machine are will be appropriate to bring the tines in the middle to horizontal designed for an easier placement of large...
Preparation Upper cutlery basket The upper cutlery basket is designed for small dishes, or long items that cannot fit into the lower cutlery basket. After taking out the basket by lifting it up, remove the carrier part from the rails by pulling it towards yourself (C).
Operating the product On/Off key 5. Salt indicator 2. Programme Selection / Programme Not in use Cancel (3 seconds) key 7. Start / Cancel indicator 3. Function keys 8. Time Delay / Programme Time indicator Half Load Function 9. Time Delay key Fast+ Function 10.
Page 26
Operating the product 25 / 39 EN Dishwasher / User’s Manual...
Operating the product Auxiliary functions AquaIntense Function AquaIntense impeller Washing programmes of your dishwasher located under the are designed to obtain the best cleaning lower impeller helps effect, considering the type of the soiling, washing your heavily soiling degree and properties of the dishes soiled dishes places in to be washed.
Operating the product Scheduling the washing Interior Lighting (Depends on the model) time Some models have interior lighting to Time Delay illuminate the interior when the door is If an economical electricity tariff is applied opened. in your region, you can use the Time Changing the interior lighting Delay function to wash your dishes during setting...
Operating the product To cancel the Time Delay function The machine will remain silent Press and hold the Programme in pause mode for some time Selection / Programme Cancel keys for in order to remove the water 3 seconds. from the machine and on the 2.
Operating the product Water cut-off warning Rinse Aid indicator ( ) If mains water is cut or water inlet tap Please check the rinse aid indicator on the is turned off the machine cannot take display to see whether there is adequate water in and E:02 icon will flash on the amount of rinse aid in the dishwasher or programme indicator.
Maintenance and cleaning Cleaning the filters Service life of the product extends and frequently faced problems decrease if it is Clean the filters at least once a week in order cleaned at regular intervals. for the machine operates efficiently. Check if food residues are left on the filters.
Maintenance and cleaning Cleaning the impellers 4. Clean all three filters under tap water by means of a brush. Clean the impellers at least once a week in 5. Replace the metal/plastic filter. order for the machine operates efficiently. 6. Place the coarse filter into the Lower impeller microfilter.
Maintenance and cleaning Upper impeller Top Impeller Check if the holes on the upper impeller (1) Check if the holes on the top impeller (1) are clogged. If they are clogged, remove of your machine are clogged. If they are and clean the impeller.
Troubleshooting Machine does not start. • Power cable is unplugged. >>> Check if the power cable is plugged in. • Fuse is blown. >>> Check the fuses in your house. • Water is cut. >>> Make sure that the water inlet tap is open. • Door of the machine is open. >>> Make sure that you have closed the door of the machine. • On / Off button is not pressed. >>> Make sure that you have turned on the machine by pressing the On / Off button. Dishes are not washed clean • Dishes are not placed orderly in the machine. >>> Load the dishes as described in the user manual. • Selected programme is unsuitable. >>> Select a programme with a higher temperature and cycle time. • Impellers are stuck. >>> Prior to starting the programme, turn the lower and upper impellers by hand to make sure that they rotate freely. • Impeller holes are clogged. >>> Lower and upper impeller holes might be clogged with food remnants such as lemon pips.
Page 35
Troubleshooting • Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse aid if necessary. Increase the rinse aid setting if there is enough amount of rinse aid in the machine. • Machine is unloaded right after the programme is over. >>> Do not unload your machine right after washing process is completed. Slightly open the door and wait for evacuation of the steam inside for a while. Unload the dishes after the pieces cool down to a touchable level.
Page 36
Troubleshooting the filling process. Run the prewash programme to remove the salt that spilled inside the machine. Since the salt granules that will remain under the lid will dissolve during prewash, causing the lid loosen, check the lid once again at the end of the programme. There is a different odour in the machine A new machine has a peculiar odour.
Page 37
Troubleshooting Detergent remains in detergent dispenser. • Detergent dispenser was damp when adding detergent. >>> Make sure that the detergent dispenser is dried well prior to filling it with detergent. • Detergent is added long before the washing process. >>> Pay attention to add detergent shortly before start-up of the washing. • Opening of the detergent dispenser lid is prevented during washing. >>> Place the dishes in a way that will not prevent the detergent dispenser lid from opening and the water going into the machine from impellers.
Page 38
Troubleshooting A smear remains on glasses that resembles milk stain which can not be removed when wiped by hand. A bluish / rainbow appearance occurs when the glass is pointed to light. • Excessive rinse aid is used. >>>Lower rinse aid setting. Clean the spilled rinse aid when adding rinse aid. • Corrosion has occurred on glass due to soft water. >>> Measure the hardness of the supply water appropriately and check the water hardness setting.
The cost of functional replacement • parts, but excluding consumable is recommended for all Washing items. Machines, Dishwashers and Electric The labour costs of a Beko approved Cookers • repairer to carry out the repair Gas Cookers must only be installed by •...
Page 40
If you have purchased an extended guarantee please refer to the instructions contained within the extended guarantee agreement document. Otherwise please call the appropriate number above where service can be obtained at a charge. Should you experience any difficulty in obtaining service please contact the Beko Customer Help-Line. Tel: 0845 6004911 e-mail: service@beko.co.uk...