Table of Contents
Advertisement
Quick Links
COMBO DRIVE
SM-348
User's Guide
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be deter-mined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Advertisement
Table of Contents
Summary of Contents for Samsung SM-348
- Page 1 COMBO DRIVE SM-348 User's Guide FCC Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
-
Page 2: Table Of Contents
CAUTION Do not attempt to repair the COMBO drive yourself. Solving Technical Problems Contact your dealer or local SAMSUNG representative for all repairs. Technical Specifications If you make any adjustments or perform any operations other than those specified in this guide, you run the risk of exposure to hazardous radiation. -
Page 3: Your Combo Drive
1. Two-pin digital audio output terminal for use with a sound or MPEG card The SM-348 COMBO drive supports RPC phase II. In the RPC-2 mode, the local supporting digital audio features code can be changed by users. -
Page 4: Installing The Combo Drive
Installing the COMBO Drive To install your COMBO drive in the PC, proceed as follows. Connecting the IDE cable Insert the IDE cable (40-pin), which is connected to the hard disk to the interface Make sure that the PC is powered off and disconnected from any power source. terminal. -
Page 5: Installing The Cd Record Utility
Digital Output Terminal The SAMSUNG COMBO SM - *** device name is displayed. The SAMSUNG device driver enables discs in the COMBO drive to be read but not recorded in an MS-DOS environment; the driver is located in the D driver folder on the CD record utility disc. -
Page 6: Setting Up The Device Driver
Set up and run the SOFT MPEG program supplied as an accessory. Copy the files from the diskette to the C:\SAMSUNG directory. To do so, type COPY A: * . * C:\SAMSUNG after the C:\prompt and press [Enter]. Storing and Cleaning Your Discs Edit the CONFIG.SYS file. -
Page 7: Solving Recording Problems
Solving Recording Problems If you have any problems recording via your COMBO drive, follow the appropriate instructions below for the source that you are using. Hard Drive CD-ROM Drive Check whether the source file is corrupted. Clean the source CD, if necessary. Optimize the hard disk by using the Windows defragmenter feature: Create an image file and then copy the image file to the COMBO drive. -
Page 8: Caution With Errors
PC while recording/deleting data, this may cause errors. VERBATIM, MAXELL How to cancel (select) the Auto-Run function CD-RW Ricoh, Samsung, CMC, Ritek, SKC Cancel (Select) the Auto-Run function in [Start > Setting > Control Panel > General DMA Installation Guide System > Device Manager > CD-ROM Setting] (Windows 95/98/Me) Use image files when you record many small files. -
Page 9: Solving Technical Problems
Reinstall the device driver or update it with the Clean the disc and try again. latest version by downloading it from the recognized by MS-DOS. Samsung Web site. The COMBO drive is not The interface mode of the sound card is AT-BUS. - www.samsung-ODD/odd.com... -
Page 10: Technical Specifications
Technical Specifications SAMSUNG continually strives to improve its products. Both the design specifications and these user instructions are thus subject to change without notice. ITEM CD-RW DVD / CD DISC Disc types supported DVD-ROM, DVD-VIDEO, DVD-R, DVD+R, DVD-RW, DVD+RW, in read mode...