Table of Contents
Advertisement
- FC EJ05 (CCIN 2B1C)
– You must use one of the following expansion drawer cables: FC ECC6, FC ECC7, FC ECC8, FC ECC9,
FC ECCR, FC ECCS, FC ECCX, FC ECCY, or FC ECCZ.
• If you have a CCIN 50CD PCIe3 6-slot fanout module:
– You must install one of the following PCIe3 cable adapters:
- FC EJ19 (CCIN 6B53)
- FC EJ1R (CCIN 58FF)
- FC EJ20 (CCIN 2CF5)
– You must use one of the following expansion drawer cables: FC ECCR, FC ECCX, FC ECCY, or FC ECCZ.
Procedure
1. Take appropriate precautions for avoiding electric shock and for handling static-sensitive devices. For
more information, see "Avoiding electric shock" on page 49 and "Handling static-sensitive devices"
on page 51.
2. If applicable, open the rack door at the rear of the system.
3. Review the locations of the PCIe adapter slots and the service indicators for the PCIe adapter that
you want to service. The PCIe adapters are installed in the rear of the system. Figure 13 on page 20
shows the locations of the PCIe adapters in a 9040-MR9 system and the locations of the light-
emitting diodes (LEDs) for the PCIe adapter.
The number of the PCIe adapter slots that are available in the system depends on the number of
system processors in the system. For the PCIe adapter placement information for the available slots
in this system, see PCIe adapter placement rules and slot priorities for the 9040-MR9.
The PCIe adapter has two LEDs that indicate the status:
• A power/activity LED (green)
• An error and identify function LED (amber)
The status of the LEDs are as follows:
• (B) Indicates that the PCIe adapter is operating correctly. The green power LED (top LED) is lit solid
and the amber fault LED (bottom LED) is off.
• (C) Indicates that the PCIe adapter is not operating correctly. The green power LED (top LED) is lit
solid and the amber fault LED (bottom LED) is lit solid.
• (D) Indicates the faulty or failed PCIe adapter was selected by using the identify function. The
green power LED (top LED) is lit and the amber fault LED (bottom LED) is flashing.
Attention: If the PCIe adapter is operating correctly, then the Activity LED is ON (green) and
the Error amber LED is OFF, as shown in (B). Do not attempt to remove a working PCIe
adapter.
Installing, removing, and replacing PCIe adapters in the 9040-MR9 system 19
Advertisement
Table of Contents
