Table of Contents
Advertisement
3
Installing the Debris Guard
to the Front Axle
Parts needed for this procedure:
1
Debris guard
1
Bracket
5
Rivet
Procedure
Use 5 rivets to install the bracket and debris guard to
the front axle
(Figure
3).
Left side of the machine shown.
1. Bracket
2. Debris guard
Figure 3
3. Rivet
4
Installing the Cutting Unit
to the Traction Unit
Parts needed for this procedure:
2
Hex-head bolt
2
Washer
2
Height-of-cut pin
Procedure
1.
Park the machine on a level surface, move
the lift arms to the lowest position, engage the
parking brake, shut off the engine, and remove
the key.
2.
Position the cutting unit in front of the traction
unit.
3.
Slide the PTO-shaft yoke onto the gearbox shaft
and secure the shafts together with 2 bolts and
nuts in opposite directions
g312858
1. Gearbox
2. PTO shaft
4.
Tighten the bolts and nuts
to the machine Operator's Manual for torque
specifications.
5.
Push a lift arm down until the holes in the lift arm
line up with the holes in the castor arms, then
insert a washer and bolt through both arms.
6.
Align the lift-arm holes with the castor-arm holes.
9
(Figure
4).
Figure 4
3. Bolts and nuts
(Figure
4); refer
g299646
Advertisement
Table of Contents
