Table of Contents
Advertisement
34
C
leaning and Maintenance
When there is a fear of freezing
• Close the water taps and remove the Water Supply Hose.
• Remove the water which remains in the water supply.
• Lower the drain hose and drain any remaining water left in by spining
If frozen
• Remove the water supply hose, and immerse it in Hot water at approx.. 40°C.
• Pour approx.. 2 liters of Hot water at approx.. 40°C, into the bowl and let it stand for 10 minutes.
• Connect the water supply hose to the water tap and confirm that the washing machine performs the
supply and drainage of water.
Wash Inner-tub
Inlet Hoses Exterior Hoses connection washer to faucet should be replace every 5 years. Immediately
Long Vacations
Cleaning the Inside of your Washer
If you use fabric softener or do regular Cold water washing, it is very important that you occasionally clean
the inside of your washer.
• Fill your washer with Hot water.
• Add about two cups of powerdered detergent that contain phosphate
• Let it operate for several minutes.
• Stop the washer, open the lid leave it to soak overnight.
• After soaking, drain the washer and run it through a normal cycle.
Or use Tub Clean Program periodically.
We do not recommend that you wash clothes during this procedure.
Products that might damage your washing machine
• Concentrated bleaches and diaper sanitizer will cause damage to the paint work and components of
your washer.
• Hydrocarbon solvents i.e. petrol, paint thinners and lacquer thinners, etc. can dissolve plastic and blister
paint (Be careful when washing garments stained with these solvents as they are flammable DO NOT
put them in washer or dryer without presoaking and rinsing them first.)
• Some pretreatment sprays or liquids can damage your washer' s control panel.
• Use of dyes in your washer may cause staining of the plastic components. The dye will not damage the
machine but we suggest you thoroughly clean your washer afterwards. We do not recommend the use
of dye strippers in your washer.
• Do not use your washer lid as a work surface.
Leave the lid open after washing to allow moisture to evaporate. If you want to
clean the inner-tub use a clean soft cloth dampened with liquid Detergent, then
rinse. (Do not use harsh or gritty cleaners.)
wipe off any spills. Wipe with damp cloth. Try not to hit surface with sharp objects.
Do not use stain removal sprays or agents on, near or next to the machine.
Doing so can damage the machines finish and cause corrosion
Be sure water supply is shut off at the tape. Drain all water from hoses if weather
will be below freezing.
Advertisement
Table of Contents
