Page 1
Washing machine WAW24440IN en Instruction Manual and Installation Instructions...
Page 2
Your new washing machine Display rules : Warning! You have chosen a Bosch washing machine. This combination of symbol and signal word indicates a possibly dangerous Please take a few minutes to read and situation. Not heeding the warning can become familiar with the advantages of cause death or injuries.
Safety instructions If you lean on the washing Safety instructions ■ machine door when it is open, the washing machine Electrical safety may tip over and cause S a f e t y i n s t r u c t i o n s injuries.
Environmental protection Keep detergents and care Warning products out of the reach of Danger of death! children. Children may lock themselves in appliances, putting their lives Warning at risk. Risk of injury! For appliances that have When you wash at high reached the end of their service temperatures, the glass in the life:...
Always fill the appliance with the ■ authorized collection centers for maximum amount of laundry for the disposal relevant programme. www.bosch-home.com/in/about- Overview of programmes bosch/responsibility.html ~ Page 14 See also: Wash normally soiled laundry Contact No: 180042535287 (toll-free) ■...
Main points in brief Main points in brief M a i n p o i n t s i n b r i e f Connect the mains Open the door. To switch on, press Select a plug. Turn on the the # button.
Getting to know the appliance Getting to know the appliance Washing machine G e t t i n g t o k n o w t h e a p p l i a n c e Detergent drawer ~ Page 20 Operating/display panel Door with door handle 9S Open the door...
Getting to know the appliance Control panel All the buttons are sensitive Note: H Changing the default programme (except for the main switch) and only settings: ~ Page 18 need to be pressed lightly. Temperature (Temp. °C) , ■ Spin speed (rpm 0), ■...
Getting to know the appliance Display panel Further information Programme progress: Prewash Washing Rinse à Spin - 0 - Programme end Default programme settings: Programme end during Rinse Stop ( Temperature in °C - P - Pause, e.g. to reload laundry Ž...
Laundry Some examples of soiling levels can Laundry be found on ~ Page 13 – Light: Do not prewash, select the P repare the laundry SpeedPerfect ( setting if L a u n d r y necessary Caution! – Normal Damage to the appliance/fabrics –...
Detergent Saving energy and detergent Detergent For light and normal soiling, you can C orrect selection of detergent save energy (lower washing D e t e r g e n t temperature) and detergent. The care label is crucial for selecting the correct detergent, temperature and Saving Soiling/note...
Overview of programmes Overview of programmes Programmes on the programme selector O v e r v i e w o f p r o g r a m m e s Programme/type of laundry/information Settings Programme name Max. load Brief explanation of the programme and for which fabrics it is Temperature that can be selected (Ž...
Page 15
Overview of programmes Programme/type of laundry/information Settings Delicate / Silk Max. 2 kg For delicate, washable fabrics, e.g. made of silk, satin, synthetic Ž - 40 °C fibres or blends (e.g. silk blouses, silk scarves) $ - 800 rpm Use a detergent suitable for machine-washing delicates Note: EcoPerfect F, SpeedPerfect (, or silk.
Page 16
Overview of programmes Programme/type of laundry/information Settings *** Allergy Plus Max. 7 kg/5* kg Hard-wearing fabrics made of cotton or linen Ž - 60 °C Note: Particularly suited to washing items that need to be hy- $ - 1600** rpm gienically clean and especially kind to sensitive skin thanks to the EcoPerfect F, SpeedPerfect (, longer wash cycle at a defined temperature, higher water level...
Overview of programmes Programme/type of laundry/information Settings *** Duvet Max. 2.5 kg Machine-washable items stuffed with synthetic fibres, such as Ž - 60 °C pillows, quilts and bedspreads; also suitable for items stuffed $ - 1200 rpm with down EcoPerfect F, SpeedPerfect (, Note: Wash large items separately.
Programme default settings Ready in ñ Programme default Before starting the programme, you settings can preselect the programme end ("Ready in" time) in hourly increments (h The default programme settings are = hour) up to a maximum of 24 hours. P r o g r a m m e d e f a u l t s e t t i n g s displayed in the display panel after selecting the programme.
Additional programme settings Additional programme Operating the settings appliance Preparing the washing An overview of all additional settings, A d d i t i o n a l p r o g r a m m e s e t t i n g s O p e r a t i n g t h e a p p l i a n c e which can be selected depending on machine...
Operating the appliance The maximum load and the duration Measure and add detergent ■ of the programme (alternately) and care products In appliances with a drum light: Caution! The drum is lit after switching on the Damage to the appliance appliance, after opening and closing the Cleaning agents and agents for pre- door and after starting the programme.
Operating the appliance Pour the detergent and care products For models without a measuring aid, into the appropriate compartments: pour the liquid detergent into the appropriate dispenser and place it in the drum. Change the programme default settings You can use or change the default settings for this washing cycle.
Operating the appliance Start the programme Adding laundry Press the A button. The indicator lamp After starting the programme, you can lights up and the programme starts. add or remove laundry if necessary. The display panel shows the "Ready in" Press the A button to do this.
Appliance settings For programmes at low temperatures: Press the A button. Select Spin or Drain . Press the A button. Programme end during rinse hold Leave the door and detergent ■ drawer open so that any residual In the display panel, $ flashes, and the water can evaporate.
Sensors Activating the setting mode Exiting setting mode To exit and save the settings, press the Press the # button. # button. The appliance is switched on and the Cottons programme is shown at The appliance is switched off. The position 1.
Cleaning and maintenance Machine housing/control Cleaning and panel maintenance Wipe the housing and the control ■ Warning panel with a soft, damp cloth. C l e a n i n g a n d m a i n t e n a n c e Remove the detergent residue Danger of death! ■...
Cleaning and maintenance Fit the insert and lock it in place Carefully unscrew the pump cover; (push the cylinder onto the guide residual water may leak out. pin). Clean the interior, pump-cover Push in the detergent drawer. thread and pump housing. The impeller in the drain pump must be Leave the detergent drawer open Note:...
Cleaning and maintenance The drain hose at the siphon Filter in the water supply is blocked blocked Switch off the appliance. Pull out the First, reduce the water pressure in the mains plug. supply hose: Loosen the hose clamp. Carefully Turn off the tap.
Faults and what to do about them. Pull the emergency release Faults and what to do downwards with a tool and release. The door can then be opened. about them. Emergency release F a u l t s a n d w h a t t o d o a b o u t t h e m . E.g.
Faults and what to do about them. Information on the display panel Display Cause/Remedy - P - and ¼ The door is unlocked. It is possible to add laundry. - P - The temperature is too high. Wait until the temperature drops. ■...
Page 30
Faults and what to do about them. Faults Cause/Remedy The drum briefly jerks or Not a fault – the internal motor test may cause the drum to jerk or judder briefly judders after the pro- when the wash programme starts. gramme has started.
After-sales service Faults Cause/Remedy The display panel/indica- Has there been a power failure? ■ tor lamps do not work Have the fuses blown? Reset/replace the fuses. ■ while the appliance is run- If the fault occurs repeatedly, call customer services. ■...
Consumption rates Consumption rates Energy and water consumption, programme duration and C o n s u m p t i o n r a t e s residual moisture for the main washing programmes (approximate values) Programme Load Energy consump- Water consump- Programme dura- tion**...
Technical data Technical data Dimensions: T e c h n i c a l d a t a 850 x 600 x 590 mm (height x width x depth) Weight: 70 - 85 kg (depending on model) Mains connection: Mains voltage 220 - 240 V, 50 Hz Nominal current 10 A Nominal power 1900 –...
Positioning and connecting Installation surface Useful tools Spirit level for aligning ■ Spanner with: The washing machine be stable Note: ■ – WAF13 for loosening the so that it does not move around. transport braces, and The installation surface must be firm ■...
Positioning and connecting Installing the appliance in a Take the hoses out of the holders. kitchenette Warning Danger of death! There is a risk of electric shock if you touch live components. Do not remove the appliance covering plate. Unscrew and remove all four transport brace screws.
Positioning and connecting Hose and cable lengths Water inlet Left-hand connection Warning ■ Danger of death! There is a risk of electric shock if you touch live components. Do not immerse the Aqua-Stop safety valve in water (it contains an electric valve).
Positioning and connecting When the tap is open, the water flow Water outlet rate is at least 8 l/min. Warning If the water pressure is higher than this, Risk of scalding! a pressure-reducing valve must be When you are washing at high installed.
Positioning and connecting Levelling Drainage into a siphon ■ The connection point must be Align the appliance using a spirit level. secured using a hose clamp with a diameter of 24 - 40 mm (available Incorrect alignment may result in loud from specialist dealers).
Positioning and connecting Electrical connection Grounding Instructions Warning Warning Danger of death! Danger of death! Improper connection of the ground may There is a risk of electric shock if you result in electric shock. Have the touch live components. appliance checked by a qualified Never touch or hold the mains plug ■...
Positioning and connecting Before washing for the first Transportation time E.g. when moving house The washing machine was thoroughly Preparatory work: tested before leaving the factory. In Turn off the tap. order to remove any water which may Reduce the water pressure in the be left over from the test, run the first supply hose: ~ Page 27;...
Aqua-Stop warranty Before switching on the appliance Aqua-Stop warranty again: Notes Only for appliances with Aqua-Stop A q u a - S t o p w a r r a n t y The transport braces must be ■ In addition to warranty claims against removed.
Page 44
0344 892 8979 (Calls charged at local or mobile rate.) 01450 2655 (0.03 € per minute at peak. Off peak 0.0088 € per minute.) You can find the contact information for all countries in the attached after-sales service directory. Robert Bosch Hausgeräte GmbH Carl-Wery-Straße 34 81739 München, GERMANY *9001061774*...