Installation ...5 Door Removal Instructions ...7 Connecting Water Supply ...9 Controls ...10 Storage Features ...12 www.frigidaire.com USA 1-800-944-9044 & Care TA B L E O F C O N T E N T S Automatic Ice & Water Dispenser ...13 Changing the Filter ...15...
Freezer door is level across the top Leveling Refrigerator is level, side-to-side and tilted 1/4” (6mm) front-to-back Toe grille is properly attached to refrigerator Cabinet is setting solid on all corners Electrical Power House power turned on ...
Junked or abandoned refrigerators or freezers are still dangerous – even if they will sit for “just a few days”. If you are getting rid of your old refrigerator or freezer, please follow the instructions below to help prevent accidents.
Back 1 inch NOTE If your refrigerator is placed with the door hinge side against a wall, you may have to allow additional space so the door can be opened wider. INSTALLATION Toe Grille Installation and removal To install toe grille 1 Open both doors.
For best use of drawers and freezer baskets, the refrigerator should be in a position where both the refrigerator and freezer doors can be fully opened. Guidelines for final positioning of your refrigerator: • All four corners of the cabinet must rest firmly on...
2 Remove the two screws from the top hinge. Lift the door off of the bottom hinge and set it aside. 3 Remove the two bottom hinge screws and hinge if necessary. Adjustable Hinge (some models) To reinstall the refrigerator door, reverse the above steps. DOOr rEMOVAL INSTrUCTIONS Tools Necessary: Phillips Head ™...
DOOr rEMOVAL INSTrUCTIONS To remove the freezer top hinge cover: 1 Remove the two screws from each cover over the top door hinges. 2 Lift hinge cover straight up and off. To remove the freezer door: 1 Detach the multi-wire cable connector located above the top hinge.
Electrolux recommends its Smart Choice water® line kit 5305510264 (with a 20 ft. Copper Water Line with self-tapping saddle valve). Please refer to www.frigidaire.com/store for more information. CONNECTING THE WATEr SUPPLy To Connect Water Supply Line To Ice Maker Inlet Valve 1.
CONTrOLS User Interface Your refrigerator is equipped with a user interface display. Touch an icon (Water/Cube/Crush) to activate the desired dispenser mode. light on-off On / Off control lock Press and hold for three (3) seconds to activate and deactivate. This restricts undesired changes to the refrigerator’s settings and prevents...
User Interface Your refrigerator is equipped with a user interface display. It is only necessary to touch the glass. There is no need to press with force. Touch an icon (Water/Cube/Crush) to activate the desired dispenser mode. light on-off On / Off...
See “Glass Shelves” in Care & Cleaning Chart. Cantilever Shelf Adjustment Refrigerator shelves are easily adjusted to suit individual needs. Before adjusting the shelves, remove all food. Cantilever shelves are supported at the back of the refrigerator.
IMPORTANT Your ice maker is turned on at the factory so it can work as soon as you install your refrigerator. If you cannot connect a water supply, turn the ice maker’s On/Off switch to Off. Otherwise, the ice maker’s fill valve may make a loud chattering noise when it attempts to operate without water.
CAUTION Chemicals from a malfunctioning water softener can damage the ice maker. If the water supply to your refrigerator is softened, be sure the softener is maintained to work properly. Cleaning the Ice Maker Clean the ice maker and ice bin at regular intervals, particularly before you take a vacation or move.
Water Filter Status on the user interface prompts you to replace the filter after a standard amount of water (200 gallons/757 liters for PureSource 3 through the system. If your refrigerator has not been used for a period of time (during moving for example), change the filter before reinstalling the refrigerator. Ordering replacement Filters To order your replacement filters, please visit our online store at www.frigidaire.com/store, by calling toll-free...
NOrMAL OPErATING SOUNDS AND SIGHTS Understanding the Sounds you may Hear Your new, high-efficiency refrigerator may introduce unfamiliar sounds. These sounds normally indicate your refrigerator is operating correctly. Some surfaces on floors, walls, and kitchen cabinets may make these sounds more noticeable. Following is a list of major components in your refrigerator and the sounds they can cause: A Evaporator Refrigerant through the evaporator may create a boiling or gurgling sound.
IMPORTANT If you store or move your refrigerator in freezing temperatures, be sure to completely drain the water supply system. Failure to do so could result in water leaks when the refrigerator is put back into service. Contact a service representative to perform this operation.
When new ice is made, dispenser should operate. • Remove ice cubes that are jamming the dispenser. • Close both doors gently. • Ensure floor is level and solid, and can adequately support the refrigerator. Contact a carpenter to correct a sagging or sloping floor. • Ensure floor is level and solid, and can adequately support the refrigerator. Contact a carpenter to correct a sagging or sloping floor. •...
Page 19
Clean condenser. See Care & Cleaning. • This is normal. Refrigerator goes on and off to keep tem- perature constant. • Call your Frigidaire service representative, who can inter- pret any messages or number codes flashing on the digital displays. • Open household water line valve. See AUTOMATIC ICE MAKEr.
3. Rust on the interior or exterior of the unit. 4. Products purchased “as-is” are not covered by this warranty. 5. Food loss due to any refrigerator or freezer failures. 6. Products used in a commercial setting. 7. Service calls which do not involve malfunction or defects in materials or workmanship, or for appliances not in ordinary household use or used other than in accordance with the provided instructions.