Table of Contents
Advertisement
5.
Disable ME jumper (3-pin DIS_ME)
This jumper allows you to enable or disable the Intel
jumper to pins 1-2 to enable (default) the Intel
disable it.
Connector type
6.
Chassis intrusion header (4-1 pin CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The
chassis intrusion sensor or switch sends a high-level signal to this connector when
a chassis component is removed or replaced. The signal is then generated as a
chassis intrusion event.
By default, the pin labeled "Chassis Signal" and "Ground" are shorted with jumper
caps. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
Connector type
2-12
HEADER 1x3p, 2.54mm pitch, S/T
CHASSIS
PIN 1
HEADER 4p, K2, 2.54mm pitch
ME function. Set this
®
ME function and to pins 2-3 to
®
Q470EI-IM-A
Advertisement
Table of Contents
