16. ACCESSORIES......................37 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
The appliance must be connected to the water mains • using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. Old hose sets must not be reused. • If the mains power supply cable is damaged, it must •...
ENGLISH access to the mains plug after the • Do not put flammable products or installation. items that are wet with flammable • Do not touch the mains cable or the products in, near or on the appliance. mains plug with wet hands. •...
Page 6
7. Remove the polystyrene protection from the bottom. 3. Remove the internal film. 8. Pull up the appliance in vertical position. 4. Open the door and remove the polystyrene piece from the door seal and all the items from the drum.
Page 7
ENGLISH 11. Pull out the plastic spacers. 12. Put the plastic caps, that you find in the user manual bag, in the holes. The appliance must be level and stable. A correct adjustment of the appliance level prevents the vibration, noise and the movement of the appliance when in operation.
Page 8
If this occur, close the water tap and contact the authorized service centre to replace the hose. 3.5 Water drainage The drain hose should stay at a height of not less than 60 cm and not more than Make sure that the inlet hose 100 cm.
ENGLISH 5. Without the plastic hose guide: Put Make sure that the drain the drain hose in the spigot and hose end is not immersed in tighten it with a clip. Refer to the the water. There may be a illustration.
Page 10
• The Vlekken option pre-treats and water than necessary. stubborn stains optimizing the • The steam as a quick and easy way to effectiveness of the stain remover. refresh the clothes. The gentle steam •...
ENGLISH 5. CONTROL PANEL 5.1 Control panel description 11 10 Programme dial Delay start touch button (Startuitstel) Display Steam Plus touch button (Plus Steam) Eco touch button (Eco) Time saving touch button (Tijd Spin reduction touch button (TPM) Besparen) Rinse touch button (Spoelen) •...
Page 12
5.2 Display Maximum load indicator. The indicator flashes during the laundry load estimation (refer to ProSense load detection paragraph) . Maximum laundry indicator. It blinks if the laundry amount exceeds the declared load. Door locked indicator. Delay start indicator.
ENGLISH Time saving indicator. Spin speed indicator. Rinse hold indicator. Extra silent indicator. Temperature indicator. The indicator appears when a cold wash is set. 6. KNOB AND BUTTONS 6.1 Aan /Uit When the display shows the indicators , the appliance does not Pressing this button for a few seconds heat the water.
Page 14
The display shows the indicator in order to improve its effectiveness. The door stays locked. The drum turns regularly to reduce creasing. This option is not You must drain the water to unlock available with a the door.
ENGLISH After touching theStart/Pauze button, • In case of smaller load, touch this button twice to set an extra quick the display shows the indicator programme. the selected delay time and the appliance begins the countdown. The display shows the indicator This option can also be used 6.8 Spoelen to shorten the Stoom...
Page 16
Programme Programme description White cotton and coloured cotton. Normal soil and light soil. Standard programmes for the Energy Label consumption Katoen values. According to regulation 1061/2010, the programme Katoen at 60 °C and the programme Katoen at 40 °C with the option are respectively the «Standard 60°C cotton pro-...
Page 17
ENGLISH Programme Programme description White cotton items. This programme removes micro-organ- isms thanks to a washing phase with the temperature main- Anti-Allergie tained above 60°C for some minutes. This helps in removing germs, bacteria, micro-organism and particles. An additional rinsing phase ensures a proper removal of detergent residues and pollens/allergenic items.
Page 18
Programme Programme description Maintenance cycle with hot water to clean and freshen the drum and to remove residue that may cause odour. For the Machine Clean best result use this cycle once a month. Before run this cycle, remove all items from the drum. In the washing phase com- partment of the detergent dispenser, put the flap of the com- partment in upward position.
Page 19
ENGLISH Programme Default tempera- Maximum spin speed Maximum ture Spin speed range load Temperature range 1600 rpm 60 °C 9 kg 1600 rpm - 400 rpm Anti-Allergie 30 °C 1200 rpm 3 kg 40 °C - 30 °C 1200 rpm - 400 rpm 20 min.
Options ■ ■ ■ ■ ■ ■ ■ Tijd Besparen ■ ■ ■ ■ ■ ■ ■ ■ ■ Startuitstel ■ ■ ■ Plus Steam ■ ■ ■ ■ ■ Soft Plus 1) This option is not available with temperature lower than 40 °C.
ENGLISH 8.2 Acoustic signals 8.3 Permanent Extra Rinse This appliance is provided with different With this option you can permanently acoustic signals, that operate when: have an extra rinse when you set a new programme. • You activate the appliance (special short tune).
Page 22
4. Close the door firmly. Always follow the instructions that you find on the packaging of the detergent products, but we recommend that you do not exceed the maximum indicated level ( ). This quantity will however guarantee the best washing results.
Page 23
ENGLISH 4. To use liquid detergent, turn the flap The indicator of the Start/Pauze button down. flashes. The display shows the maximum declared load for the programme, the default temperature, the maximum spin speed, the washing phase indicators (when available) and an indicative programme duration.
Page 24
Cancelling the delay start after In this case, for 30 seconds, it is possible to pause the appliance and remove the the countdown has started exceeding garments. To cancel the delay start: Once removed the exceeding garments, touch the Start/Pauze button to start the 1.
Page 25
ENGLISH 10.12 Opening the door The steam phase is running: If the temperature and level The anti-crease phase is running: of the water in the drum are too high and/or the drum still rotates you cannot open the door. 10.10 Interrupting a While a programme or the delay start programme and changing the operates, the appliance door is locked.
10.14 Draining water out after 4. Press the Aan /Uit button a few seconds to deactivate the appliance. end of cycle In any case, the appliance If you have chosen a programme or an empties the water out option that does not empty out the...
ENGLISH • A very small load can cause balance • To help the environment, do not use problems with the spin phase leading more than the recommended quantity to excessive vibration. If this occurs: of detergent. a. interrupt the programme and •...
Page 28
12.2 Descaling 12.5 Cleaning the drum Regularly examine the drum to prevent If the water hardness in your rust particles. area is high or moderate, we recommend that you use a For a complete cleaning: water descaling product for 1.
Page 29
ENGLISH Clean the drain pump if: • The appliance does not drain the water. • The drum does not turn. • The appliance makes an unusual noise because of the blockage of the drain pump. • The display shows the alarm code WARNING! •...
Page 30
5. When the bowl is full of water, close 10. Clean the filter under the water tap. the drainage duct back and empty the container. 6. Repeat the steps 4 and 5 until the water stops to flow out.
Page 31
ENGLISH When you drain the water with the emergency drain procedure, you must activate the drain system again: a. Put 2 litres of water in the main wash compartment of the detergent dispenser. b. Start the programme to drain the water.
2. Close the water tap. WARNING! 3. Put the two ends of the inlet hose in Make sure that the a container and let the water flow out temperature is higher than 0 of the hose. °C before you use the 4.
Page 33
ENGLISH Problem Possible solution Make sure that the appliance door is closed. Make sure that there is not a damaged fuse in the fuse box. Make sure that the Start/Pauze has been touched. If the delay start is set, cancel the setting or wait for the end of countdown.
Page 34
Problem Possible solution There is water on the Make sure that the couplings of the water hoses are tight and floor. there is not water leakages. Make sure that the drain hose have no damages. Make sure you use the correct detergent and the correct quan- tity of it.
ENGLISH After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Authorised Service Centre. If the display shows other alarm codes. Deactivate and activate the appliance. If the problem continues, contact the Authorised Service Centre. 13.3 Emergency door opening To open the door, proceed as follows: 1.
The tumble dryer can be stacked on the top of the washing machine only by www.aeg.com/shop or from using the correct stacking kit authorised dealer manufactured and approved by AEG. Only appropriate Verify the compatible accessories approved by stacking kit by checking the AEG ensure the safety depth of your appliances.
Page 38
17. ENVIRONMENTAL CONCERNS marked with the symbol with the Recycle the materials with the symbol household waste. Return the product to Put the packaging in applicable your local recycling facility or contact containers to recycle it. Help protect the your municipal office.