Related Manuals for LG JTNQ36GNLE5
Summary of Contents for LG JTNQ36GNLE5
- Page 1 OWNER’S MANUAL ROOM AIR CONDITIONER 4-WAY CEILING CASSETTE MFL67850901 P/No. MFL67850901_v3...
-
Page 2: Table Of Contents
TABLE OF CONTENTS TABLE OF CONTENTS TIPS FOR SAVING OWNER'S ENERGY INSTRUCTION IMPORTANT SAFETY Cooling Mode - Standard Operation INSTRUCTIONS Cooling Mode - Power Cooling Auto Operation Mode BEFORE USE Dehumidification Mod Preparing for operation Fan Mode Usage Temperature Setting/ Cleaning and maintenance Room Temperature checking Service... -
Page 3: Tips For Saving Energy
TIPS FOR SAVING ENERGY TIPS FOR SAVING ENERGY Here are some tips that will help you minimize the power consumption when you use the air conditioner. You can use your air conditioner more efficiently by referring to the instructions below: •... -
Page 4: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE. Always comply with the following precautions to avoid dangerous situations and ensure peak performance of your product WARNING It can result in serious injury or death when the directions are ignored CAUTION It can result in minor injury or product damage when the directions are ignored WARNING... - Page 5 IMPORTANT SAFETY INSTRUCTIONS Operation • Take care to ensure that power cable could not be pulled out or damaged during operation. There is risk of fire or electric shock. • Do not place anything on the power cable. There is risk of fire or electric shock. •...
- Page 6 IMPORTANT SAFETY INSTRUCTIONS CAUTION Installation • Always check for gas (refrigerant) leakage after installation or repair of product. Low refrigerant lev- els may cause failure of product. • Install the drain hose to ensure that water is drained away properly. A bad connection may cause water leakage.
-
Page 7: Before Use
BEFORE USE BEFORE USE Preparing for operation • Contact an installation specialist for installation. • Use a dedicated circuit. Usage • Being exposed to direct airflow for an extended period of time could be hazardous to your health. Do not expose occupants, pets, or plants to direct airflow for extended periods of time. •... -
Page 8: Product Introduction
"LG Electronics India Pvt. Ltd" All collection centre and pick up facilities are done by third parties with LG ls o k,a iz n ku dj jgh gks a ] ls djok,a A Electronics India Pvt. Ltd. merely as a facilitator. -
Page 9: Operation Indication Lamps
PRODUCT INTRODUCTION Operation Indication Lamps Forced operation : Operation procedures when remote control can’t be used. Defrost Mode : Lights up during defrost mode or hot start operation. (heat pump model only) Timer : Lights up during timer operation. Signal Receptor : Receives the signal from remote control (signal receiving sound: two short beeps and one long beep) Filter sign : Lights up after 2400 hours from the time of first operation. -
Page 10: Wireless Remote Controller
PRODUCT INTRODUCTION Wireless Remote Controller This air-conditioner is equipped with wireless remote controller basically. But if you want to be available with wired remote controller, you pay for it. VANE ANGLE Button Used to set each vane angle. FUNCTION SETTING Button Used to set or clear Auto Clean, Smart Clean, Electric heater or Individual vane angle control. - Page 11 PRODUCT INTRODUCTION CAUTION Caution of handling the Remote Controller • Aim at the signal receiver on the wired remote controller so as to operate. • The remote control signal can be re- ceived at a distance of up to about 7m. •...
-
Page 12: Operating Instruction
OPERATING INSTRUCTION OPERATING INSTRUCTION How to insert the Batteries Wireless Remote Controller Maintenance Remove the battery cover by pulling it accord- ing to the arrow direction. Choose a suitable place where its safe & easy Insert new batteries making sure that the (+) to reach. -
Page 13: Installation Instructions
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS Installer Setting - How to enter installer setting mode CAUTION Installer setting mode is to set the detail function of the remote controller. If the installer setting mode is not set correctly, it can cause problems to the product, user injury or property damage. -
Page 14: Installer Setting - Installer Setting Code Table
INSTALLATION INSTRUCTIONS Installer Setting - Installer Setting Code Table Installer Setting Code Table Function Function Code Setting Value Remote Controller LCD 0 : Set to Master Mode Override 1 : Set to Slave 1 : Standard 2 : Low Ceiling Height Selection 3 : High 4 : Super High... -
Page 15: Installer Setting - Setting Address Of Central Control
INSTALLATION INSTRUCTIONS Installer Setting - Setting Address of Central Control . With the MODE button pressed, press the RESET button. . By using the temperature setting button, set the indoor unit address. • Setting range : 00 ~ FF . After setting the address, press the ON/OFF button toward the indoor unit 1 time. -
Page 16: Owner'sinstruction
OWNER'S INSTRUCTION OWNER'S INSTRUCTION Cooling Mode Cooling Mode - Power Cooling - Standard Operation . Press the ON/OFF button. . Press the ON/OFF button. The unit will respond with beep sound. The unit will respond with beep sound. . Press MODE button to select Cooling . -
Page 17: Auto Operation Mode
OWNER'S INSTRUCTION Auto Operation Mode ❈ Please select the code depend on your feeling. Code Feel Cold Slightly cool Neutral Slightly warm Warm During Auto Operation Mode • If the system is not operating as de- sired, manually switch to another mode. -
Page 18: Dehumidification Mod
OWNER'S INSTRUCTION Dehumidification Mod During Dehumidification Mode • If you select the dehumidification mode on the operation selection button, the indoor unit starts to run the dehumidifi- cation function, automatically setting the room temp. and air volume to the best condition for dehumidification based on the sensed room temp. -
Page 19: Fan Mode
OWNER'S INSTRUCTION Fan Mode Natural Wind by the chaos Logic • For more fresh feeling than other fan speed, press the Indoor Fan Speed Se- lector and set to chaos mode. In this mode, the wind blows like natural breeze by automatically changing fan speed according to the chaos logic. -
Page 20: Temperature Setting/Room Temperature Checking
OWNER'S INSTRUCTION Temperature Setting/Room Temperature checking We can simply adjust the desired tem- perature • Press the buttons to adjust the desired temperature : Increase 1˚C or 1˚F per one time pressing : Decrease 1˚C or 1˚F per one time pressing Room temp: Indicate the current room temperature Set temp: Indicate the temperature that... -
Page 21: Airflow Setting
OWNER'S INSTRUCTION Airflow Setting Up/Down Airflow Direction Control (Optional) The up/down airflow (Vertical Airflow) can be adjusted by using the remote controller. . Press the ON/OFF button to start the unit. . Press up/down airflow button and the louvers will swing up and down. Press the up/down airflow button again to set the vertical louver at the desired airflow direc- tion. -
Page 22: Plasma Purificationoptional)
• Plasma filter is a technology developed by tion will start when the button is pressed LG to get rid of microscopic contaminants in and stop when the button is pressed again. the intake air generating a plasma of high charge electrons. -
Page 23: Individual Vane Angle Control
OWNER'S INSTRUCTION Individual vane angle control It is the function that can control 4 vane an- . Press SET/CLEAR button to reserve or can- gles individually in the ceiling type 4Way cas- cel the individual vane angle control func- sette product group. tion. -
Page 24: Timer
OWNER'S INSTRUCTION Timer Setting the Current Time 1. Press the SET/CLEAR button for 3 seconds. 2. Press TIME SETTING buttons until the desired time is set. 3. Press the SET / CLEAR button. NOTE Check the indicator for A.M. and P.M. Timer Setting 1. - Page 25 MAINTENANCE AND SERVICE MAINTENANCE AND SERVICE Indoor Unit Remove the Air filters. ille, Case and Remote Control Take hold of the tab and pull slightly forward to remove the filter. - Turn the system off before cleanining, To clean, wipe with a soft, dry cloth. Do not use CAUTION bleach or abrasives.
-
Page 26: Purifying Filer(Optional)
MAINTENANCE AND SERVICE Purifying filer(Optional) Open front panel and remove air filter. Cleaning The PLASMA filter behind the air filters should be checked and cleaned once every 3 months or more often if necessary. Remove air purifying filter. Insert new air purifying filter. After removing the air filters, pull slightly for- ward to remove the PLASMA filter. -
Page 27: Operation Tips
MAINTENANCE AND SERVICE Operation Tips! Do not overcool the room. Keep blinds or curtains closed. Keep the room temperature uniform. This is not good for the health Do not let direct sunshine and wastes electricity. enter the room when the air Adjust the vertical and hori- conditioner is in operation. -
Page 28: Troubleshooting Tips! Save Time And Money
MAINTENANCE AND SERVICE Troubleshooting Tips! Save time and money! Check the following points before requesting repairs or service..If the malfunction persist, please contact your dealer. The air conditioner The room has a pecu- It seems that conden- Air conditioner does does not operate.