Table of Contents
Advertisement
Faults and what to do about them
en
Faults
Drying time too long?
Display panel goes off
and Start button flashes.
Residual water in the
condensation container
despite the dryer being
connected to the con-
densation drain*.
Humidity in the room
increases.
Power cut.
Unusual noises when
drying.
The dryer feels cold
despite drying.
* Depending on the model
Note:
If you cannot rectify the fault yourself by turning the dryer off and then on again,
please contact our after-sales service.
34
Cause/remedy
The fluff filter may be dirty and cause a longer drying time. Clean the fluff fil-
■
ter.
If the air inlet on the dryer is blocked or not freely accessible, this may
■
increase the drying time. Make sure that the air inlet remains unobstructed.
The optimum ambient temperature for drying is between 15 °C and 30 °C.
■
Outside of this range, the drying time may increase.
Insufficient air circulation in the room may increase the drying time. Venti-
■
late the room.
Not a fault. Energy-saving mode is active ~ Page 12.
Not a fault. If the condensation drain is installed, residual water remains in the
condensation container due to the dryer's self-cleaning function.
Not a fault. Make sure the room is sufficiently ventilated.
The drying programme is interrupted. Remove the laundry and spread it out or
restart the programme.
Not a fault. Noises are produced by the automatic cleaning of the heat
exchanger ~ Page 31.
Not a fault. The dryer can dry efficiently at low temperatures using a heat pump.
Advertisement
Table of Contents
