Table of Contents
Advertisement
PREPARATION
STAND INSTALLATION
■ Image shown may differ from your TV.
When assembling the desk type stand, check
whether the bolt is fully tightened. (If not tightened
fully, the product can tilt forward after the product
installation.) If you tighten the bolt with excessive
force, the bolt can deviate from abrasion of the
tightening part of the bolt.
1
Carefully place the TV screen side down
on a cushioned surface to protect the
screen from damage.
2
Assemble the parts of the Stand Body with
the Stand Base of the TV.
3
Assemble the TV as shown.
4
Fix the 4 bolts securely using the holes in
the back of the TV.
5
Assemble the parts of the Stand Rear
Cover with the TV. (Only 32/42/47LD7 *** )
Stand Rear
Cover
A-16
BACK COVER FOR
WIRE ARRANGEMENT
■ Image shown may differ from your TV.
1
2
Stand Body
Stand Base
3
►Do not use the Cable Management Clip to lift
the TV.
- If the TV is dropped, you may be injured or the
TV may be damaged.
Connect the cables as necessary.
To connect additional equipment, see the
External Equipment Setup section.
Open the Cable Management Clip as
shown.
Fit the Cable Management Clip as shown.
NOTE
Cable Management Clip
- Quick Links:
- Wireless Network Connection
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
