Table of Contents
Advertisement
FITTING INTO THE CABINET
IMPORTANT: Ensure that the oven is
switched off at the wall before any
further work is carried out.
Using a tape measure establish the internal width
of the cabinet. Refer to page 47 if greater than
565mm.
Position the appliance in front of the cabinet. See
Fig. 8.
Take out all oven furniture before installation to
reduce the weight you need to lift. The oven door
should be taped up to keep it closed whilst lifting.
To place the appliance into the cabinetry follow the
procedure below:
N.B. Two people will be required to carry out
the lifting procedure.
Warning: Do not attempt to lift this
appliance by the handle(s).
Each person should squat either side of the
appliance.
Tilt the appliance so that your hands can support
the underside of the appliance.
Keeping your back straight, raise the appliance to
the cabinet by straightening at the knees.
Rest the rear underside of the appliance on the
cabinet floor while your hands support the front.
The appliance can be pushed fully into the cabinet.
Take care to avoid damaging the mains lead.
Ensure the appliance is central in the cabinet and
level.
Do not remove spacer fitted behind fixing holes.
When the appliance is fully housed screw the
stability screws (supplied with the appliance) into
the side of the cabinet taking care not to distort
the side trims (See Fig. 9). It is advisable to turn
each screw alternately to avoid damaging the
trims.
Switch on the appliance then refer to the operating
instructions.
Fig.8
(Cable not supplied)
Fig.9
52
Advertisement
Table of Contents
