Table of Contents
Advertisement
Available languages
Available languages
Display Luminosity (Optional)
The Display Luminosity can be adjusted by using the remote control.
Press the start/stop button to start the unit. Open the door on the remote control, press the 2ndF button
and, press display luminosity button.
Display will be dark. Press the button again to set bright display.
Forced operation
Operation procedures when the remote control can't be used.
The operation will be started if the ON/OFF button is pressed.
If you want to stop operation, re-press the button.
Cooling Model
Operating mode
Cooling
Indoor FAN Speed
High
Setting Temperature
22°C
Test operation
During the TEST OPERATION, the unit operates in cooling mode at high speed fan, regardless of room
temperature and resets in 18 minutes.
During test operation, if remote controller signal is received, the unit operates as remote controller sets.
If you want to use this operation, Press and hold the ON/OFF button for 3~5 seconds, then the buzzer sound
1 "beep".
If you want to stop the operation, re-press the button.
Room Temp. ≥ 24°C
21°C ≤ Room Temp. < 24°C
Cooling
Healthy Dehumidification
High
22°C
Operating Instructions
Heat pump Model
High
23°C
ON/OFF
button
Room Temp. < 21°C
Heating
High
24°C
Owner's Manual
13
Advertisement
Chapters
Table of Contents
