Intended use Cleaning and maintenance . . . 24 Intended use Overall condition of the machine . . . 24 I n t e n d e d u s e Special salt and rinse aid ..24 This appliance is intended for Filters .
Safety instructions Delivery The electrical connection conditions must correspond 1. Check the packaging and with the specifications dishwasher immediately for on the dishwasher rating plate 92. damage caused in transit. Do not switch on a damaged If the power cord of this appliance, but contact your appliance is damaged, supplier.
Safety instructions If you cannot obtain any In daily use information from Read and observe the safety the manufacturer, you must information and instructions not install the dishwasher for use on the packaging above or below these for cleaning and rinsing agents. appliances.
Safety instructions Disposal Warning Risk of explosion! 1. Make redundant appliances Do not add any solvents unusable to prevent to the washing chamber. subsequent accidents. Danger of explosion! 2. Dispose of the appliance in a n environmentally friendly Warning manner. Risk of scalding! Warning Open the door carefully when...
Protection of the environment Ensure that children do not Protection of the place fingers in the tablet environment collecting tray 12. Small fingers could become i o n P r o t e c t o f t e n v i r o n m e n t caught in the slots.
Getting to know your appliance Appliance interior Getting to know your appliance 1" Top basket G e t t i t o k n o w y o u r a p p l i a n c 1* Knife shelf * Diagrams of the control panel 12 Tablet collecting tray and the interior of the appliance can be...
Water softening system/Special salt 5. Hold down button > P and press Setting START button h until the dry display ` and salt refill The amount of salt dispensed can be indicator )* flash. set in 4 stages depending on the hardness of your 6.
Rinse aid As soon as the salt refill indicator )* Rinse aid on the fascia is lit, top up the salt. R i n s e a i d As soon as the rinse-aid refill indicator )" is lit on the fascia, there is still a rinse-aid reserve of 1-2 rinsing processes.
Utensils 3. Close cover until it clicks shut. Switching off rinse-aid refill 4. To prevent excessive foam formation indicator during the next rinse cycle, remove any rinse aid which has run over with If the rinse-aid refill indicator )" is a cloth.
Utensils Recommendation: Cups and glasses Use only glasses and porcelain Top basket 1" which the manufacturer designates as dishwasher-proof. Use a detergent which protects utensils. Take glass and cutlery out of the dishwasher as soon as possible after the programme ends. Loading the dishwasher 1.
Utensils Pans Cutlery basket Bottom basket 1b You should always place cutlery unsorted with the points downwards. To prevent injuries, place long, pointed implements and knives on the knife shelf. E tagere * E t a g e r e Heavily soiled utensils (pans) should The etagere and the space underneath be placed in the bottom basket.
Utensils F olding spikes * Knife shelf * F o l d i n g s p i k e s K n i f e s h e l f * depending on model * depending on model The spikes can be folded down to Long knives and other utensils can be improve arrangement of pans, bowls arranged horizontally.
Detergent Top basket with side levers Detergent 1. Pull out the top basket 1" out. D e t e r g e You can use tablets as well as powder 2. To lower the basket, press in the left or liquid detergents for dishwashers, but and then the right lever on the never use washing up liquid.
Detergent Adding detergent If the utensils are only lightly soiled, 1. If the detergent dispenser 9" is still slightly less than the indicated amount closed, press the lock 9* to open of detergent is usually adequate. the detergent dispenser. Suitable detergents and care products Pour detergent into the dry detergent can be purchased online dispenser 9"...
Page 18
Detergent Notes You will obtain optimum rinsing and drying results by using solo detergents and applying salt and rinse aid separately. If programmes are short, tablets may not have full cleaning effect due to different dissolving properties and there may even be undissolved detergent residue.
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia.
Additional options Ï Programme selection Intensive zone * I n t e n s i v e z o n e You can select a suitable programme Perfect for a mixed load. You can wash according to the type of utensils and very soiled pots and pans in the lower degree of soiling.
Operating the appliance Switching on the appliance Operating the appliance 1. Turn on the tap fully. 2. Open the door. O p e r a t i i a n c e t h e a p p l 3. Switch on ON/OFF switch (. Programme data The Eco 50°...
Operating the appliance O ptical display while End of programme O p t i c a l d i s p l a y w h i l e t h e p r o g r a m m e i s r u n n i n g the programme is running * The programme has ended when neither of the two displays ` or X...
Operating the appliance Interrupting the programme Intensive drying 1. Open the door. The final rinse uses a higher temperature which improves the drying 2. Switch off ON/OFF switch (. result. The running time may increase The LEDs go out. The programme is slightly.
Cleaning and maintenance Never use a steam cleaner to clean your Cleaning and dishwasher. The manufacturer is not liable for any consequential damage. maintenance Regularly wipe the front of the appliance C l e a n i a n d n a n c e m a i n t e and fascia with a damp cloth;...
Cleaning and maintenance Filters Spray arms The filters 1R keep large foreign Limescale and contaminants in the objects in the rinsing water away from rinsing water may block nozzles and bearings on the spray arms 1: and the pump. These foreign objects may occasionally block the filters.
Fault, what to do? In this case: Fault, what to do? 1. First always disconnect F a u l t , w h a t d o ? the appliance from the power supply. Experience has shown that you can 2.
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display )2 lights up. Tap turned off. Turn the tap on. Tap jammed or calcified. Turn the tap on. Flow rate must be min.
Page 28
Fault, what to do? Fault Cause Remedial action Displays flash. Door not closed properly. Close the door. Ensure that no objects (utensil, fragrance dispenser) are protruding over the basket and preventing the door from closing. Refill indicator for salt )* No rinse aid.
Page 29
Fault, what to do? Fault Cause Remedial action Cutlery not dry. Cutlery not arranged properly in Separate cutlery if possible, prevent contact the cutlery basket. points. Cutlery not arranged properly in Arrange cutlery properly and separate if the cutlery drawer. possible.
Page 30
Fault, what to do? Fault Cause Remedial action Detergent residue. Detergent dispenser cover Detergent dispenser cover must not be blocked by utensils and therefore obstructed by utensils. does not open fully. Do not place utensils or fragrance dispenser in the tablet collecting tray. Detergent dispenser cover Tablet must be inserted flat and not upright.
Page 31
Fault, what to do? Fault Cause Remedial action White, stubborn coatings; Detergent substances are Change detergent brand. limescale on the utensils, deposited. These coatings cannot Clean appliance mechanically. container or door. usually be removed with chemicals (appliance cleaner, ...). Hardness range incorrectly set or Set water softening system according to water hardness greater than 8.9 instructions for use or top up salt.
Page 32
Fault, what to do? Fault Cause Remedial action Removable streaks on Too much rinse aid. Set rinse aid amount to lower setting. glasses, glasses with No rinse aid added or setting too Add rinse aid and check dosage metallic appearance and low.
Page 33
Fault, what to do? Fault Cause Remedial action The door is difficult to Child lock is activated. Deactivate child lock. (See instructions for open. use at the back) Door cannot be closed. Door lock has been activated. Close door with increased force. Door cannot be closed due to Check appliance installation: Door installation.
Customer service Customer service Installation and connection C u s t o m e r s e r v i c e If you are unable to rectify the fault, l a t i o n I n s t a l a n d c o n n e c t i please contact your customer service.
Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions can thoroughly in the factory to ensure that it be found in the installation instructions. is in working order. This may cause Level the appliance with the aid of the small water stains.
Installation and connection Waste-water connection Water pressure: At least 0.05 MPa (0.5 bar), maximum 1. The required work sequence can be 1 MPa (10 bar). At a higher water found in the installation instructions. pressure: connect pressure-reducing If required, fit a siphon with an valve ahead.
Installation and connection Electrical connection Removing the appliance Connect the appliance to an Also observe alternating current only, ranging from the sequence of worksteps here. 220 V to 240 V and 50 Hz or 60 Hz 1. Disconnect the appliance from via a correctly installed socket with the power supply.
Installation and connection Transportation Protection against frost P r o t e c t i o n a g a i n s t f r o s t ( E m p t y i n g t h e a p p l i a n c e ) Empty the dishwasher and secure loose If the appliance is in a room where there parts.
Page 40
*9000889353* 9000889353 en (9407) 640EV...