Table of Contents
Advertisement
APPENDIX: AUTO SETUP STATE (read only)
Response data of One Push Auto White Balance (AWB), One push Auto BLACK Balance (ABB), One push
Auto Shading (ASC) and One Push (Color DTL Auto Setup) are shown.
-Response data-
4000xx h
xx: 00h- Normally finished,
Error code
11h
Turn off the color bar
12h
(WHITE BALANCE) change to Manual
13h
Increase the intensity of illumination, turn lens iris to ward open direction, or increase the gain to provide a
proper video level.
14h
Decrease the intensity of illumination, turn lens iris toward closed direction, or decrease the gain to provide a
proper video level.
15h
The color temperature is too high, making it impossible to reach the optimum value in adjustment.
(If there is no problem in practical application, use the camera under the current condition.)
Add a filter to the lens or illumination to decrease the color temperature.
16h
The color temperature is too low, making it impossible to reach the optimum value.
(If there is no problem in practical application, use the camera under the current condition.)
Add a filter to the lens or illumination to increase the color temperature.
18h
Carry out auto setup again. If this message appears in repeated attempts, it is necessary to inspect the inside
of the camera. In this case, notify your local Hitachi Denshi sales agent or Hitachi Denshi service office
31
others- Error has occurred. Refer to following table.
Countermeasure
Advertisement
Table of Contents
