Table of Contents
Advertisement
en Troubleshooting
Fault
Appliance does not start.
Programme starts automat-
ically.
Appliance stops during the
programme or cuts out.
Mechanical damage
Fault
Appliance door cannot be
closed.
Lid on the detergent dis-
penser cannot be closed.
52
Cause
Mains cable is not inserted.
Appliance door is not closed
properly.
You did not wait until pro-
gramme ended.
Appliance door is not closed
properly.
Power and/or water supply
has been interrupted.
Top basket is pressing
against inner door and pre-
venting appliance door from
being closed securely.
Cause
Door lock has been activ-
ated.
Door cannot be closed due
to installation method.
Detergent dispenser or lid
are blocked by sticky deter-
gent residue.
troubleshooting
Check whether the socket works.
1.
Check whether the mains cable is
2.
properly inserted in the socket and
on the rear of the appliance.
Close the appliance door.
▶
→ "Terminate programme",
▶
Page 33
Close the appliance door.
▶
Check the power supply.
1.
Check the water supply.
2.
Check whether the rear panel of the
▶
appliance is being pressed in by a
socket or hose holder that has not
been removed.
Arrange the tableware so that no
▶
parts project beyond the basket
and prevent the appliance door
from closing properly.
troubleshooting
Close the appliance door with
▶
greater force.
Check whether the appliance has
▶
been installed properly.
When closed, the appliance door,
its decor or attached parts should
not knock against adjacent cabin-
ets or the worktop.
Remove detergent residue.
▶
Advertisement
Table of Contents
