Installation In A Rack; Desktop Installation - Cisco AS5400 Quick Start Manual

Cisco systems universal gateway quick start guide

Table of Contents

Installation in a Rack

Install the chassis in the rack. Rack-mounting screws are not provided. Use two screws for each side (supplied with the rack).

Installing the Cisco AS5350 in a Rack (19-Inch Rack)

Note: The second bracket attaches to the rack at the other side

of the chassis. The chassis can also be installed with the

front panel forward.

Installing the Cisco AS5400 in a Rack (19-Inch Rack)

Note: The second bracket attaches to the rack at the other side

of the chassis. The brackets can also be installed with the

front panel forward.

For desktop or shelf mounting, use the rubber "feet" shipped on a black adhesive strip with the chassis. They protect the chassis

and provide a nonskid surface.

The location of the chassis is extremely important for proper operation. Equipment placed too close together, inadequate

ventilation, and inaccessible panels can cause malfunctions and shutdowns, and can make maintenance difficult. The following

information will help you to plan the location of the chassis:

• Plan for access to both front and rear panels of the chassis.

• Ensure that the room where the chassis operates has adequate ventilation. Remember that electrical equipment generates

heat. Ambient air temperature may not cool equipment to acceptable operating temperatures without adequate ventilation

To attach the rubber feet, take the following steps:

Step 1

Locate the rubber feet that shipped with the chassis.

Place the universal gateway upside-down on a smooth, flat surface.

Step 2

Table of Contents

As5350