Table of Contents
Advertisement
Available languages
Available languages
•
Make sure that the oil level is not lower than the
To do a check of the oil level on
minimum. Refer to
page 12 .
•
Make sure that all screws are tightened.
•
Make sure that all levers are placed in neutral
position.
Introduction
WARNING: Before you assemble the
product, carefully read and understand the
safety chapter and the assembly
instructions.
To assemble or replace the blade
The blade of the cable layer has a lot of parts. You need
to assemble these parts before install the blade to the
product.
1. Install the sealing ring, the spacer and the threaded
bushing in order onto the structure of the blade.
2. Loosen the threaded bushing, put the hose through
the threaded bushing until the hose comes out from
the lower part with distance of about 5 mm.
3. Tighten the threaded bushing with a wrench.
4. Lock the hose.
1394 - 002 - 27.11.2019
•
Clean the air filter if there is impurities.
•
Move the gas lever to START position when start the
cold engine.
Assembly
5. Assemble the left and right cable holding guides.
6. Install the blade to the product.
To assemble the cable
There are many cable types and reel types available in
the market, so the product is equipped with a removable
clutched cable winder.
1. Wrap the cable into the cable winder with the lever
provided on the winder.
Note: Make sure that the cable is wrapped clockwise so
that it can be smoothly unwinded during the work.
5
Advertisement
Chapters
Table of Contents
