Table of Contents
Advertisement
en Water softening system
hardness. The higher the water hard-
ness, the greater the consumption of
special salt.
ATTENTION!
¡ Detergent may damage the water
softening system.
Only fill the dispenser of the wa-
▶
ter softening system with special
dishwasher salt.
¡ Special salt for dishwashers can
damage the tub due to corrosion.
To make sure that any special
▶
salt that escapes is washed out
of the tub, add the special salt
to the dispenser for special salt
immediately before the pro-
gramme starts.
Unscrew the lid of the dispenser
1.
for special salt and remove.
On initial start-up: Fill the dispenser
2.
right up with water.
Note: Only use special salt for
3.
dishwashers.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dis-
penser.
Fill the dispenser right up with spe-
cial salt. The water in the dis-
penser is displaced and forced
out.
Place the lid back on the dis-
4.
penser and turn to close.
26
Switching off the water
softening system
If you find the special salt refill indic-
ator irritating, e.g. when using com-
bined detergents with salt replace-
ment substances, you can switch the
indicator off.
Note
To avoid damage to the appliance, only
switch off the water softening system in
the following cases:
¡ The water hardness is max. 26 °E
and you are using combined deter-
gents with salt replacement sub-
stances. According to manufactur-
ers, combined detergents with salt
replacement substances can gen-
erally only be used up to a water
hardness of 26 °E without adding
special salt.
¡ The water hardness is 0 - 8 °E.
You do not need to use special
salt.
Press
.
1.
To open the basic settings, press
2.
for 3 seconds.
a The display shows Hxx.
a The display shows
Press
repeatedly until the dis-
3.
play shows H00.
To save the settings, press
4.
for 3 seconds.
a The water softening system is
switched off and the salt refill indic-
ator is deactivated.
.
Advertisement
Table of Contents
