Table of Contents
Advertisement
Removing the Cable-Management System
Figure 3-6
1
Remove the optical interface cables.
Step 3
To remove the RPR/SRP uplink card SFP modules, go to the
Modules" section on page
To remove the optical cables from the DPT or POS/DPT uplink cards, go to the
Card" section on page
Removing the RPR/SRP Uplink Card SFP Modules
Before removing the optical cables from the RPR/SRP uplink card, first remove any SFP modules.
Avoid exposure to laser radiation. Do not star into an open aperture, because invisible laser radiation
Warning
may be emitted from the aperature when a cable is not inserted in the port.
Warning
Class 1 single-mode laser product.
Class 1 LED product.
Warning
You do not need to power down the router before you remove an SFP module. The router may remain
Note
powered up during this procedure.
To remove a bale clasp SFP module from the uplink card, perform the following steps:
Attach an ESD-preventive strap to your wrist, and to the router or to a bare metal surface. (See the
Step 1
"Preventing Electrostatic Discharge" section on page
Remove all optical interface cables from the SFP ports on the RPR/SRP uplink card.
Step 2
Book Title
3-6
Disconnecting the Optical Interface Cable
Optical interface cable connector
3-6.
3-8.
Chapter 3
Installing and Removing the Uplink Cards
R E S E T
C O N S
O L E A
U X
1
"Removing the RPR/SRP Uplink Card SFP
2-4.)
"Removing the Uplink
78-13113-06 B0
Advertisement
Table of Contents
Troubleshooting
