Table of Contents
Advertisement
DPT Uplink Card Faceplate and Specifications
Product Number
10720-LR1-LC-POS=
10720-LR2-LC-POS=
10720-CON-AUX=
The Cisco 10720 Internet Router provides network access using Ethernet and optional Dynamic Packet
Transport (DPT), Packet over SONET (POS), or IEEE 802.17 RPR technology for optical connectivity.
Each router is equipped with one uplink card located in the upper card slot. The OC-48 RPR/SRP,
OC-48/STM-16c DPT, and POS/DPT uplink cards are equipped with dual OC-48c/STM-16c optical
uplink network ports with an aggregate bandwidth of 5 Gbps. The console/auxiliary card provides
console and serial (AUX) ports only.
Although the console/auxiliary card does not provide uplink capabilities, it is described here because it
is installed the same as the DPT and POS/DPT uplink cards. You can use the
Cisco 10720 Internet Router console/auxiliary card with either a 24-Port 10/100 Ethernet TX access
card or a Combined 4-Port Gigabit Ethernet 8-Port 10/100 Ethernet TX access card to customize the
Cisco 10720 Internet Router as an Ethernet-only router.
For DPT and POS/DPT uplink cards, the cable connector is LC fiber-optic connector. For the RPR/SRP
uplink card, the fiber-optic cable connects to an LC connector in a small form-factor pluggable (SFP)
optical connector. When connecting to DPT networks, the left port is the Spatial Reuse Protocol (SRP)
side A, and the right port is side B. (See
individual ports. Each port consists of transmit (TX) and receive (RX). (See
connecting to DPT networks in Resilient Pack Rings (IEEE 802.17 RPR) mode, the left port is span
West, and the right port is span East. When in the Spatial Reuse Protocol (SRP) mode, the left port is
side A, and the right port is side B. (See
For information and instructions on connecting the optical cables to the DPT uplink card or to the
RPR/SRP uplink card and for setting up four-node rings, see
and
DPT Uplink Card Faceplate and Specifications
This section provides faceplate identification and specifications for the DPT uplink card.
Figure 1-1
10720-SR-LC
1
2
3
4
5
Book Title
1-2
Product Name
OC-48 POS Long Reach 40-km Uplink Module
OC-48 POS Long Reach 80-km Uplink Module
Console/Auxiliary Module
Chapter 4, "Creating a Four-Node Ring Using the Uplink Cards."
Cisco 10720 Internet Router DPT Uplink Card
1
TX
A
RX
2
3
Side A
Side A TX
Side A RX
Side B
Side B TX
Figure
1-1.) When connecting to POS networks, there are two
Figure
1-3.)
Chapter 1, "Overview and Specifications"
4
7 8
TX
B
RX
CONSOLE
AUX
5
6
6
Side B RX
7
Console port
8
Auxiliary port
9
Reset switch
Chapter 1
Overview and Specifications
Figure
1-2.) When
9
RESET
78-13113-06 B0
Advertisement
Table of Contents
Troubleshooting
