[Pr. Pt15_Software Position Limit + (Lmp)]; [Pr. Pt17_Software Position Limit - (Lmn)] - Mitsubishi Electric MR-J5-G User Manual
Hide thumbs
Also See for MR-J5-G:
- User manual (216 pages) ,
- Sample screen manual (128 pages) ,
- Introduction manual (112 pages)
Table of Contents
Advertisement
[Pr. PT15_Software position limit + (LMP)]
Initial value
0 [Refer to the text below for the unit.]
Set the address increasing side of the software position limit.
This function is enabled in the cyclic synchronous position mode, profile position mode, and positioning mode (point table
method). This function is disabled during homing.
The command unit can be changed to 0.001 mm, 0.0001 inch, 0.001 degree or pulses with [Pr. PT01.2 Unit for position data].
Change this function during servo-off, in the homing mode, velocity mode, or torque mode.
When the setting is changed during servo-on in the position mode and positioning mode, [AL. 035 Command frequency error],
[AL. 069 Command error], and [AL. 098 Software position limit warning] may occur, depending on the setting order of [Pr.
PT15] and [Pr. PT17 Software position limit -].
This function corresponds to [Max position limit (Obj. 607Dh: 02h)].
When the object is mapped to the cyclic communication, do not write values with engineering tools because the controller
overwrites the servo parameter values written with engineering tools.
The enabling/disabling conditions of the software position limit are shown in the table below.
[Pr. PT01.2]
Conditions
[Pr. PT15] > [Pr. PT17]
0 (mm)
Enabled
1 (inch)
3 (pulse)
2 (degree)
Enabled
[Pr. PT17_Software position limit - (LMN)]
Initial value
0 [Refer to the text below for the unit.]
Set the address decreasing side of the software position limit.
The other specifications are the same as [Pr. PT15].
Setting range
-2147483648 to 2147483647
[Pr. PT15] < [Pr. PT17]
Disabled
Enabled
Setting range
-2147483648 to 2147483647
1.9 Positioning control setting servo parameters group ([Pr. PT_ _ ])
Setting method
Each axis
[Pr. PT15] = [Pr. PT17]
Disabled
Disabled
Setting method
Each axis
1 SERVO PARAMETER DETAILS
Ver.
A0
Ver.
A0
161
1
Advertisement
Table of Contents
