Table of Contents
Advertisement
Chapter 3
Bringing Up the Cisco IOS XR Software on a Multishelf System
11.
12.
13.
DETAILED STEPS
Command or Action
Step 1
Power down all LCCs and FCCs.
Step 2
Apply power to the LCC that contains the DSC.
Step 3
Connect to the DSC console port and log in.
Step 4
admin
Example:
RP/0/RP0/CPU0:router# admin
Step 5
configure
Example:
RP/0/RP0/CPU0:router(admin)# configure
Step 6
dsc serial serial ID rack 0
Example:
RP/0/RP0/CPU0:router(admin-config)# dsc
serial TBA00000001 rack 0
OL-10957-02
controllers fabric plane planeNumber
oim count 1
oim instance 0 location Frack/slot/FM
commit
end
Purpose
Prepares the LCCs and FCCs for startup in the proper
sequence.
•
Each LCC and FCC should be powered up in the order
specified in this chapter.
Boots the LCC containing the DSC.
Allow the rack to fully boot.
•
Verify that "IOS XR RUN" appears on the RP faceplates.
•
See the Cisco CRS-1 documentation web page listed in
•
the
"Related Documents" section on page x
planning information including DSC placement.
Establishes a CLI management session with the router.
For more information, see the
Through the Console Port" section on page
Places the router in administration EXEC mode.
Places the router in administration configuration mode.
Defines which LCC is Rack 0.
•
The LCC containing the DSC should be configured with
the lowest rack number.
Replace serial ID with the serial number of the LCC you
•
want to configure as Rack 0.
See the
"Preparing a Rack Number Plan" section on
•
page 3-3
for information on locating the serial number.
Cisco IOS XR Getting Started Guide
Bringing Up and Configuring Rack 0
for site
"Connecting to the Router
1-9.
3-29
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
