Wall-Mounting (With Mounting Screws) - Cisco CATALYST 2960 Hardware Installation Manual
Cisco systems switch user manual
Hide thumbs
Also See for CATALYST 2960:
- Configuration manual (2288 pages) ,
- Software configuration manual (980 pages) ,
- Command reference manual (800 pages)
Table of Contents
Advertisement
Chapter 3
Switch Installation (8-Port Switches)
Wall-Mounting (with Mounting Screws)
This section is specific to the Catalyst 2960 8-port switches. For information applicable to the other
Catalyst 2960 switches, see
The steps in this section show how to mount the switch with the front panel facing down (as shown in
Figure 3-5 on page 3-12
Warning
Read the wall-mounting instructions carefully before beginning installation. Failure to use the
correct hardware or to follow the correct procedures could result in a hazardous situation to people
and damage to the system. Statement 378
Do not wall-mount the switch with its front panel facing up or sideways. According to safety regulations,
Note
wall-mount the switch with its front panel facing down to prevent airflow restriction and to provide
easier access to the cables.
Follow the steps in this section to install the switch to a wall:
Locate the screw template. The template is used to align the mounting screw holes.
Step 1
Position the screw template so that the two side-by-side slots face toward the floor, as shown in
Step 2
Figure
For the best support of the switch and cables, make sure that you attach the switch securely to a wall stud
or to a firmly attached plywood mounting backboard.
Step 3
Peel the adhesive strip off the bottom of the screw template.
OL-7075-09
Chapter 2, "Switch Installation (24- and 48-Port Switches)."
and
Figure 3-6 on page
3-5.
3-13.)
Catalyst 2960 Switch Hardware Installation Guide
Installing the Switch
3-11
Hide quick links:
Advertisement
Chapters
Table of Contents
