Leds - Cisco ASA 5508-X Manual
Hide thumbs
Also See for ASA 5508-X:
- Hardware installation manual (32 pages) ,
- Quick start manual (9 pages) ,
- Configuration manual (429 pages)
Table of Contents
Advertisement
LEDs
7
9
LEDs
The LEDs are located just off center on the front panel, and just to the left of the network ports on the rear
panel, with the SSD LED to the right of the Reset port. See
LED
Power
Status
Overview
4
USB port
A standard USB Type A port is provided,
allowing attachment of an external device such
as mass storage. See
Internal and External Flash
Storage, on page 6
for additional information.
SSD LED
Status light for installed solid-state drive (SSD).
See
LEDs, on page 4
and
Solid State Drive, on
page 7
for more information.
Description
Power supply status:
• Unlit—Power supply off.
• Green—Power supply on.
See
Power Supply Modules, on page 7
System operating status:
• Green—Normal system function.
• Amber—Critical alarm indicating one or more of the following:
8
Reset button
A small recessed button that if pressed for longer
than three seconds resets the ASA to its default
"as-shipped" state following the next reboot.
Configuration variables are reset to factory
default. However, the flash is not erased, and no
files are removed.
Note
10
SSD bay
Covered slot in which the SSD is installed. You
can replace this drive if it fails. See
Replace the SSD
Rear Panel, on page 3
• Major failure of a hardware or software component.
• Over-temperature condition.
• Power voltage outside the tolerance range.
You can use the service
sw-reset-button to disable the reset
button. The default is enabled.
for more information.
for the locations.
for additional power information.
Overview
Remove and
- Quick Links:
- Hardware Specifications
Hide quick links:
Advertisement
Table of Contents
