18. ENVIRONMENTAL CONCERNS..............45 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
This appliance is intended to be used in household • and similar applications such as: staff kitchen areas in shops, offices and other – working environments; by clients in hotels, motels, bed & breakfast and – other residential type environments;...
Page 5
ENGLISH future they must be reattached to lock be replaced, this must be carried out the drum to prevent an internal by our Authorised Service Centre. damage. • Connect the mains plug to the mains • Always take care when moving the socket only at the end of the appliance as it is heavy.
• Do not wash fabrics which are heavily hinge and seals, other seals, door soiled with oil, grease or other greasy locking assembly, plastic peripherals substances. It can damage rubber such as detergent dispensers. Please parts of the washing machine.
ENGLISH • Thanks to the Soft Plus option, the the fabric fibres favouring a perfect fabric softener is uniformly spread out softness. in the laundry and deeply penetrates 3.2 Appliance overview 11 12 Worktop Drain hose Detergent dispenser Inlet hose connection Control panel Mains cable Door handle...
Level of protection against ingress of solid particles and IPX4 moisture ensured by the protective cover, except where the low voltage equipment has no protection against mois‐ ture Water supply pressure Minimum 0.5 bar (0.05 MPa) Maximum 8 bar (0.8 MPa)
Page 9
ENGLISH 5. Carefully put the appliance down on It is possible to see its rear side. water flowing from the 6. Put the front polystyrene packaging drain hose. This is due element on the floor under the to the testing with water appliance.
Page 10
Make sure that carpets do not stop the air circulation below the appliance. Make sure that the appliance does not touch the wall or other units. 2. Loosen or tighten the feet to adjust the level. WARNING! Do not put cardboard, wood 5.3 The inlet hose...
Page 11
ENGLISH CAUTION! Make sure that there are no leaks from the couplings. Do not use an extension hose if the inlet hose is too short. Contact the service centre for the replacement of the inlet hose. 2. On the edge of a sink - Fasten the guide to the water tap or to the wall.
6. ACCESSORIES 6.1 Available in Only appropriate www.aeg.com/shop or from accessories approved by authorised dealer AEG ensure the safety standards of the appliance. If Read carefully the instructions supplied unapproved parts are used, with the accessory. any claims will be...
If you install the appliance on a plinth under the washing machine. that is not an accessory supplied by Verify the compatible AEG, secure the appliance in the fixing stacking kit by checking the plates. depth of your appliances. Read carefully the instructions supplied with the accessory.
ENGLISH Washing phase indicator. It flashes during pre-wash and wash phase. Rinsing phase indicator. It flashes during rinse phase. When the Soft Plus option is activated, the indicator appears. Spinning and draining phase indicator. It flashes during spin and drain phase.
Page 16
Touch this button repeatedly until the If you touch the Inicio/Pausa button, desired temperature value appears on the appliance performs the only the display. draining phase. When the display shows the indicators The appliance empties the water out , the appliance does not heat automatically after 18 the water.
Page 17
ENGLISH will be added in the appropriate phase A small laundry load helps to of the washing programme. reach better results. This option is not available with a 8.7 Inicio Diferido temperature lower than 40 °C. With this option you can delay the start of a programme in a more convenient time.
Put maximum two tablets or single-dose This option can also be used detergents in the Pods® compartment in to shorten the steam the detergent dispenser drawer. programme duration. The option remains active also for next cycles until it is deactivated and if it is 8.10 Pods®...
Page 19
ENGLISH Programme Programme description Cotton, synthetics and mixed items. Special steam cycle without washing that can be used to prepare your dried laundry Vapor for ironing or refreshing garments worn once . This pro‐ gramme reduces creases and odours and relaxes the fibres. When the programme is completed, quickly remove the laun‐...
Page 20
Programme Programme description White cotton items. This high-performance wash program combined with steam vapour, removes more than 99,99% of Anti-Alergia bacteria and viruses keeping the temperature above 60°C throughout the washing phase; with an additional action on the fibers thanks to a vapour phase, an enhanced rinsing phase ensures a proper removal of detergent and micro-organism residues.
Page 21
ENGLISH Programme Default tempera‐ Reference spin speed Maximum ture Spin speed range load Temperature range 30 °C 1200 rpm 3 kg 40 °C - 30 °C 1200 rpm - 400 rpm 20 min. - 3 kg 30 °C 1200 rpm 2.5 kg 40 °C - Cold 1200 rpm - 400 rpm...
ENGLISH Programme Universal Liquid Uni‐ Liquid for Delicates Special versal coloureds woollens powder Anti-Alergia ▲ ▲ -- -- ▲ 1) At temperature higher than 60 °C the use of powder detergent is recommended. ▲ = Recommended -- = Not recommended 9.2 Woolmark Wool Care - Blue The wool wash cycle of this machine has been approved by The Woolmark Company...
10.4 Permanent Extra Rinse It is suggested when you use the fabric softener. With this option you can permanently This option increases slightly have an extra rinse when you set a new the programme duration. programme. • To activate/deactivate this option To activate/deactivate this option touch touch the Aclarado / Enxag.
Page 25
ENGLISH - Compartment for washing phase (powder detergent only). Make sure that the Pods option is deactivated when using this compartment. If using liquid detergent, re‐ member to insert the con‐ tainer for liquid detergent CAUTION! Make sure that no laundry - Compartment for fabric softener stays between the seal and and other liquid treatments (fabric condi‐...
Page 26
4. Pour fabric softener in the compartment 5. Close the detergent dispenser. 12.4 Setting a programme 1. Turn the programme dial to select the desired washing programme. The related programme indicator comes The indicator of the Inicio/Pausa button flashes.
Page 27
ENGLISH The appliance starts the countdown of duration will be adjusted accordingly the delay start. and could increase or decrease. After When the countdown is completed, the further 30 seconds, the water filling programme starts. starts. At the end of the load detection, in case The ProSense estimation starts at the end of the of drum overload, the indicator...
Page 28
12.11 Opening the door - When the phase ends the relevant indicator stops flashing and is steady on. Adding garments The next phase indicator starts flashing. While a programme or the delay start E.g. the rinse phase is running: operates, the appliance door is locked.
ENGLISH 2. Remove the laundry from the 3. When the programme is completed appliance. and the door locked indicator 3. Make sure that the drum is empty. goes off, you can open the door. 4. Keep the door and the detergent 4.
Page 30
• Be careful with curtains. Remove the Do not spray stain remover on garments hooks and put the curtains in a near the appliance as it is corrosive to washing bag or pillowcase. the plastic parts. • A very small load can cause balance problems with the spin phase leading to excessive vibration.
ENGLISH • the wash load to turn grey, the laundry can then be washed at a • greasy clothes, lower temperature. • mould in the appliance. • Set the maximum possible spin speed for the selected washing Excessive detergent may cause: programme before drying your •...
Page 32
'Cleaning the inlet 1. Remove all laundry from the drum. hose and the valve filter' paragraphs. If 2. Run a cotton programme with the necessary, please contact the Authorised highest temperature with a small Service Centre.
Page 33
ENGLISH 1. Clean the drum with special products for stainless steel. Always follow the instructions that you find on the packaging of the product. 2. Run a short cotton programme at high temperature with empty drum and with a small quantity of powder detergent or, if available, run the Limp.
Page 34
CLICK 7. Make sure that all detergent residue is removed from the conveyor. Use only soft damp clothes. 8. Put bottom cover back to its position 9. Reassembly the drawer as follows: by aligning its holes on drawer hooks a.
Page 35
ENGLISH • The appliance makes an unusual noise because of the blockage of the drain pump. • The display shows the alarm code WARNING! • Do not remove the filter while the appliance operates. • Do not clean the pump if the water in the appliance is hot.
Page 36
1. Remove the inlet hose from the tap and clean the filter. 11. Put the filter back into the special guides by turning it clockwise. Make sure that you tighten the filter correctly to prevent leakages.
ENGLISH 14.12 Frost precautions If the appliance is installed in an area where the temperature can reach the values around 0° C or drop below, remove the remaining water from the inlet hose and the drain pump. 1. Disconnect the mains plug from the mains socket.
Page 38
With some problems, the display shows an alarm code and the Inicio/Pausa button may flash continuously: If the appliance is overloaded, remove some items from the drum and/or keep pressed the door while touching the Inicio/Pausa button until the indicator stops flashing (see the picture below).
Page 39
ENGLISH • The programme was not finished properly or the appliance stopped too early. Switch the appliance off and on again. Internal fail. No com‐ • If the alarm code appears again, contact the Authorised Serv‐ munication between ice Centre. electronic elements of the appliance.
Page 40
Problem Possible solution • Make sure that a washing programme that ends with water in tub, has not been selected. • Make sure that the washing programme is finished. • Set the drain or the spin programme if there is water in the You cannot open the drum.
ENGLISH 1. Press the On/Off button to switch the CAUTION! appliance off. Risk of burns! Make sure 2. Disconnect the mains plug from the that the water temperature mains socket. is not too high and the 3. Open the filter flap. laundry is not hot.
Page 42
Energy consumption. °C Temperature in the laundry. Litres Water consumption. Spin speed. Remaining moisture at the end of spinning phase. The higher is the spin speed, the higher is the noise and the lower is the remaining moisture. Values and programme duration may differ depending on different conditions (e.g.
ENGLISH Programme Litres h:mm °C Algod. 0.35 3:00 1400 20°C Sintéticos 0.80 2:15 1200 40°C Delicados 0.40 1:05 1200 30°C Lana/Lãs 0.30 1:05 1200 30°C 1) Reference indicator of the spin speed. 2) Suitable for washing heavily soiled textiles. 3) Suitable for washing lightly soiled cottons, synthetic and mixed fabrics. 4) It also performs as quick washing cycle for lightly soiled laundry.
Page 44
17.2 Cleaning the drain pump filter 180˚ Clean the filter regularly and, especially, if the alarm code appears on the display. 17.3 Programmes Programmes Load Product description White and coloured cottons. Normally soiled 9 kg garments. Eco 40-60 9 kg White cotton and coloured cotton.
ENGLISH Programmes Load Product description White cotton items. This program removes 9 kg more than 99,99% of bacteria and viruses . It Anti-Alergia also ensure a proper reduction of allergens. 1) Washing programme. 2) Washing programme and waterproofing phase. 3) Tested for Staphylococcus aureus, Enterococcus faecium, Candida albicans, Pseudomonas aerugino‐ sa and MS2 Bacteriophage in external test performed by Swissatest Testmaterialien AG in 2021 (Test Report No.