Related Documentation - Cisco Rugged Series Installation Manual

Table of Contents

Preface

Warning

Related Documentation

All of the IR8340 documentation can be found online here:

https://www.cisco.com/c/en/us/support/routers/catalyst-ir8300-rugged-series-router/series.html

When installing or replacing the unit, the ground connection must always be made first and disconnected last.

Statement 1046

Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can

come into contact with such circuits. When installing the antenna, take extreme care not to come into contact

with such circuits, because they may cause serious injury or death. For proper installation and grounding of

the antenna, please refer to national and local codes (for example, U.S.:NFPA 70, National Electrical Code,

Article 810, Canada: Canadian Electrical Code, Section 54). Statement 1052

No user-serviceable parts inside. Do not open. Statement 1073

Installation of the equipment must comply with local and national electrical codes. Statement 1074

Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement

1030

Ultimate disposal of this product should be handled according to all national laws and regulations. Statement

1040

The covers are an integral part of the safety design of the product. Do not operate the unit without the covers

installed. Statement 1077

Hot surface. Statement 1079

Cisco Catalyst IR8340 Rugged Series Router Hardware Installation Guide

Table of Contents

Catalyst ir8340