Table of Contents
Advertisement
Available languages
Available languages
Perform Auto Install
Note
Installation and set-up of the AMR network to be read out must have been completed.
1. Press the function key and keep it pressed for approx. 2 sec (long press) until the LED lights up green.
The device connects to the S GCP.
P
The remaining steps are run through automatically.
P
Displays during auto install
The device starts setting up the link to the S GCP. The buzzer generates a short tone,
the LED flashes green and the display shows the "SYnC" message with flashing antenna
symbol
The mobile radio signal strength
in the location are shown on the display:
•
•
•
If the mobile radio signal is too weak, correct your position.
Starting the scanning process. The buzzer generates a short tone, the LED flashes green
and the display shows the "SCAn" message with flashing Rx symbol.
The gateway now searches for network nodes within its radio range. All detected and captured networks are
shown consecutively in the display with the relevant information, each for 3 seconds. The scanning process lasts 5
minutes. During the entire scanning process the LED flashes green and the information on the captured networks is
displayed alternately (display loop).
Example:
During the scanning process the radio signal strength of the networks is updated continuously. For example,
while the display loop is running, a node with a better signal strength may have been found for a network already
displayed with a certain signal strength. This network is shown with the better signal strength the next time it is
displayed. The scanning process ends after 5 minutes.
C
B
A
(A) Consecutive number of the captured networks
(B) Network ID
Completion of the Auto Install
The network scan is ended after minutes. All captured networks are shown consecutively in the display, each for 3
seconds. Short press the function key to page forward display levels manually.
Example:
At the same time the gateway sets up a link to the S GCP and transmits the results of the network scan to the
S GCP for validity checking. The result of the check is returned to the gateway.
19.04.2022
.
= 2G (GSM, GPRS, EGPRS)
= 3G (UMTS, HSDPA, HSUPA)
&
= 4G (LTE-FDD)
and the symbol for the mobile phone standard available
(C) Radio signal strength
Installation | EN
105
Advertisement
Chapters
Table of Contents
