Table of Contents
Advertisement
Chapter 3 Installation
After you have setup your ISDN line as described in Chapter 2 you can now, turn on
your computer power ON and start the driver installation. The ISDNL
terminal adapters are communicated with by the PC as a standard modem. This
means that the terminal adapter will operate on any computer or operating system,
which supports standard modem operation (including
shows installation of the TA-200 using Microsoft Windows 31, 95, and NT.
How to Configure TA-200
Your TA-200 adapter should have been supplied to you correctly setup for your
particular country and environment for immediate operation. There should be no need
to alter the configuration of the device. However if you need to alter some of the
advanced settings of the TA then basic setup and configuration can be done through
any terminal program including ProComm, Telex, HyperTerminal and so on. To alter
the setup then configure your terminal program with the following setting values.
Baud Rate:
Data Bit:
Parity Check:
Stop Bit:
Flow Control:
Then, on the terminal screen enter the AT command, AT@. A menu should then
appear allowing you to alter your ISDN TA settings. Please note, if you are familiar with
AT command set then you may refer to Chapter 4 for details on the necessary AT
commands to allow you to control these system parameters directly.
After entering AT@, the following screen is shown below.
*************************** ISDN Utility Program ******************************
*
*
*
*
************************************************************************************
Please select one item :
Please see the appropriate section below which describes each menu item.
8
Up to 115200
8
None
1
RTS/CTS
1. Upgrade New Firmware
2. Set System Parameter
3. Set Protocol Parameter
ESC. Exit
© COPYRIGHT OF ASUSCOM NETWORK INC.
MAC, UNIX and
TA-200
INK™
PC). Below
*
*
*
*
Advertisement
Table of Contents
