Table of Contents
Advertisement
(2) Checking operation
Conductivity and power distribution status of contacts and coils can be checked by switching GX Works2 to the
monitor mode.
[Online]
When X0 and X1 are turned on, Y10 turns on. (to turn on X0 and X1, place the cursor on them and double-click
while holding the
Shift
Debug can be performed by forcibly turn on or off devices in the "Modify Value" dialog box.
[Debug]
Enter a device to
be turned on or off.
For details on current value changing, refer to the following.
GX Works2 Version 1 Operating Manual (Common)
If a program is edited during debugging, the program can be written to the CPU module even while the CPU
module is in the RUN status. (
[Monitor]
[Start Monitoring]
key.) While contacts and coils are conducting, they are shown in blue.
[Modify Value...]
Page 168, Section 3.12)
CHAPTER 1 BASIC PROCEDURE FOR PROGRAMMING
1
33
Advertisement
Table of Contents
Related Manuals for Mitsubishi Electric MELSEC-Q00U(J)CPU
Related Products for Mitsubishi Electric MELSEC-Q00U(J)CPU
- Mitsubishi Electric MELSEC System Q
- Mitsubishi Electric MELSEC-QnAS Series
- Mitsubishi Electric MELSEC-Q-MR-JE-C
- Mitsubishi Electric MELSEC-QnA series
- Mitsubishi Electric MELSEC-QS Series
- Mitsubishi Electric Melsec-Q172DCPU-S1
- Mitsubishi Electric Melsec-Q173DCPU
- Mitsubishi Electric Melsec-Q173DCPU-S1