Using The Side Discharge; Adjusting The Height Of Cut; Tow; Mow - Toro TimeCutter HD MyRide Operator's Manual
48in, 54in, or 60in riding mower
Hide thumbs
Also See for TimeCutter HD MyRide:
- Operator's manual (56 pages) ,
- Operator's manual (56 pages)
Table of Contents
Advertisement
Tow
This is the medium speed. The suggested uses for
this speed are as follows:
•
Bagging
•
Mulching
Mow
This is the fastest speed. The suggested uses for this
speed are as follows:
•
Normal mowing
•
Moving the machine
Using the Side Discharge
The mower has a hinged grass deflector that
disperses clippings to the side and down toward the
turf.
DANGER
Without a grass deflector, discharge cover, or
a complete grass-catcher assembly mounted
in place, you and others are exposed to blade
contact and thrown debris. Contact with
rotating mower blade(s) and thrown debris
will cause injury or death.
• Never remove the grass deflector from the
mower deck because the grass deflector
routes material down toward the turf. If the
grass deflector is ever damaged, replace it
immediately.
• Never put your hands or feet under the
mower deck.
• Never try to clear the discharge area
or mower blades unless you move the
blade-control switch (PTO) to the O
position, rotate the key switch to the O
position, and remove the key from the key
switch.
• Make sure that the grass deflector is in the
down position.
Adjusting the Height of Cut
The machine is equipped with a foot pedal deck-lift
system. You can use the foot pedal to lift the deck
briefly to avoid obstacles or lock the deck in the
highest height of cut or transport position. You can
use the height-of-cut lever with the foot pedal to lock
the deck in a specific cutting height.
Using the Foot Pedal Deck-Lift
System
•
Press the deck-lift pedal down to raise the deck;
continue to press the pedal until the deck locks in
the transport position
•
Push on the deck-lift pedal with your foot and pull
the transport lock handle rearward to disengage
the transport lock
FF
FF
Adjusting the Height of Cut
You can adjust the height of cut from 38 to 114 mm
(1-1/2 to 4-1/2 inches) in 6 mm (1/4 inch) increments
by moving the height-of-cut pin into different hole
locations.
1.
Push on the deck-lift pedal with your foot and
raise the mower deck to the transport-lock
position (also the 114 mm (4-1/2 inch) cutting
height position) as shown in
2.
To adjust, remove the pin from the height-of-cut
bracket
25
(Figure
27).
(Figure
27).
Figure 27
Transport Lock Position
Figure
(Figure
28).
g024409
28.
Hide quick links:
Advertisement
Chapters
Table of Contents
