Fit The Blade Guard; Connect The Power Pack; Adjusting The Blade Guard Guide - Husqvarna WS 440 HF Operator's Manual
Hide thumbs
Also See for WS 440 HF:
- Operator's manual (80 pages) ,
- Operator's manual (20 pages) ,
- Operator's manual (49 pages)
Table of Contents
Advertisement
Available languages
Available languages
ASSEMBLING AND ADJUSTMENTS
Fit the blade guard
WARNING! Never mount or dismount the
!
blade or blade guard without first pulling out
the power cable running to the saw unit.
Carelessness can result in serious personal
injury or even death.
1 Slip in the blade guard guide between the stays on the
blade guard. Place the blade guard guide in the middle.
Lock the plastic heel on the handle to the upper stay on
the blade guard.
2 Make sure that the cutting arm is positioned vertically. Lift
the blade guard over the blade and hang the guard in the
blade guard holder on the saw. Exercise care so that the
runners on the blade guard are positioned in the slots on
the water block.
3 Lock the blade guard by pulling the handle out of the
guard and then down towards the saw unit so that the
latch locks the handle.
4 To remove the guard, release the latch and pull the handle
upwards and inwards to the guard. Lock the plastic heel
on the upper stay.
10 –
English
5 Connect the water hose from the out-coupling on the saw
motor to the in-coupling on the blade flange hub.
Connect the power pack
IMPORTANT! This machine is only intended for use
together with the Husqvarna PP 440 HF and PP 480 HF
power units. All other use is forbidden.
Read through the manual supplied with the power pack before
starting to use the machine.
When the saw unit, the blade and the blade guard are
mounted, the power cable (A) and the water cooling (B)
should be connected to the power pack.
Once the power cable is connected to the saw, the carabiner
on the cable must be attached to the saw unit to prevent
pressure on the plug when in operation. The carabiner must
be fastened to one of the bracket eyes on the handle which is
screwed to the back of the drive motor.
Adjusting the blade guard guide
•
Loosen the nuts on the two adjustable guide wheels.
•
Fit the blade guard guide to the blade guard.
•
Turn the eccentric cam shafts with a 22 mm spanner until
the guide wheels touch the rail.
•
Hold the shaft in position with a 22 mm spanner and
tighten the nut with a 16 mm spanner.
•
Make sure the wheels turn easily and that there is no play
in the blade guard guide.
Advertisement
Chapters
Table of Contents
