Starting And Stopping; Before Starting; Starting; Stopping - Husqvarna WS 440 HF Operator's Manual
Hide thumbs
Also See for WS 440 HF:
- Operator's manual (80 pages) ,
- Operator's manual (20 pages) ,
- Operator's manual (49 pages)
Table of Contents
Advertisement
Available languages
Available languages
Before starting
•
Enclose the area to be cut so that unauthorised persons
can not be injured or disturb the operator.
•
Check that the blade and the blade guard is not damaged
or cracked. Replace the blade or the blade guard if it has
been exposed to impact or is cracked.
•
Check that all cables and the water supply are correctly
connected to the machine before starting it.
•
If cutting is to begin in another position than where the saw
unit is located, run the saw unit to the start position.
Starting
Follow the instructions for starting in the manual supplied with
the power pack.
Stopping
•
Once cutting is completed, remove the blade from the wall
and shut down the blade rotation and the water flow.
•
Turn off the power pack.
Dismantling the saw
1 Allow the motor to stop completely.
2 Disengage the power supply for the power pack.
3 Turn off and disconnect inflowing water to the power pack.
4 Disengage the power cable and the water hose from the
saw unit.
5 The other steps are done in the reverse order to
assembling.
Cleaning
The saw should be cleaned once cutting is finished. It is
important to clean all the saw equipment. The saw is best
cleaned with the supplied cleaning brush by connecting it to
the water hose.
IMPORTANT! Do not use a high pressure washer to clean
the saw.
16 –
English
STARTING AND STOPPING
Advertisement
Chapters
Table of Contents
