Table of Contents
Advertisement
Changing a broken or worn starter cord
•
Remove any remnants of the old starter cord and check
that the return spring works. Insert the new starter cord
through the hole in the starter housing and in the cord
pulley.
•
Secure the starter cord around the cord pulley as
illustrated. Tighten the fastening well and ensure that the
free end is as short as possible. Secure the end of the
starter cord in the starter handle.
Tensioning the recoil spring
•
Guide the cord through the cut-out in the periphery of the
pulley and wind the cord 3 times clockwise around the
centre of the starter pulley.
•
Now pull the starter handle and in doing so tension the
spring. Repeat the procedure once more, but this time
with four turns.
•
Note that the starter handle is drawn to its correct home
position after tensioning the spring.
•
Check that the spring is not drawn to its end position by
pulling out the starter line fully. Slow the starter pulley with
your thumb and check that you can turn the pulley at least
a further half turn.
Changing a broken recoil spring
•
Undo the bolt in the centre of the pulley and remove the
pulley.
•
Bear in mind that the return spring lies tensioned in the
starter housing.
•
Loosen the bolts holding the spring cassette.
MAINTENANCE
•
Remove the recoil spring by turning the starter over and
loosen the hooks, with the help of a screwdriver. The
hooks hold the return spring assembly on the starter.
•
Lubricate the recoil spring with light oil. Fit the pulley and
tension the recoil spring.
Fitting the starter
•
To fit the starter, first pull out the starter cord and place the
starter in position against the crankcase. Then slowly
release the starter cord so that the pulley engages with
the pawls.
•
Tighten the screws.
Fuel system
General
•
Check that the fuel cap and its seal are not damaged.
•
Check the fuel hose. Replace when damaged.
Fuel filter
•
The fuel filter sits inside the fuel tank.
•
The fuel tank must be protected from contamination when
filling. This reduces the risk of operating disturbances
caused by blockage of the fuel filter located inside the
tank.
•
The filter cannot be cleaned but must be replaced with a
new filter when it is clogged. The filter should be
changed at least once per year.
Air filter
The air filter only needs to be checked if the engine drops in
power.
– 23
English
Advertisement
Table of Contents
