Table of Contents
Advertisement
Register the Threat Defense with the Management Center
Set the following parameters:
• Host—Enter the IP address or hostname of the threat defense you want to add. You can leave this field
blank if you specified both the management center IP address and a NAT ID in the threat defense initial
configuration.
Note
• Display Name—Enter the name for the threat defense as you want it to display in the management center.
• Registration Key—Enter the same registration key that you specified in the threat defense initial
configuration.
• Domain—Assign the device to a leaf domain if you have a multidomain environment.
• Group—Assign it to a device group if you are using groups.
• Access Control Policy—Choose an initial policy. Unless you already have a customized policy you
know you need to use, choose Create new policy, and choose Block all traffic. You can change this
later to allow traffic; see
Cisco Firepower 1010 Getting Started Guide
26
In an HA environment, when both the management centers are behind a NAT, you can register
the threat defense without a host IP or name in the primary management center. However, for
registering the threat defense in a secondary management center, you must provide the IP
address or hostname for the threat defense.
Allow Traffic from Inside to Outside, on page
Threat Defense Deployment with the Management Center
40.
Advertisement
Chapters
Table of Contents
