Table of Contents
Advertisement
Perform Initial Configuration Using the CLI
• Configure IPv4 via DHCP or manually?—Choose manual. Although you do not plan to use the
Management interface, you must set an IP address, for example, a private address. You cannot configure
a data interface for management if the management interface is set to DHCP, because the default route,
which must be data-interfaces (see the next bullet), might be overwritten with one received from the
DHCP server.
• Enter the IPv4 default gateway for the management interface—Set the gateway to be data-interfaces.
This setting forwards management traffic over the backplane so it can be routed through the manager
access data interface.
• Manage the device locally?—Enter no to use CDO. A yes answer means you will use the device manager
instead.
• Configure firewall mode?—Enter routed. Outside manager access is only supported in routed firewall
mode.
Example:
You must accept the EULA to continue.
Press <ENTER> to display the EULA:
End User License Agreement
[...]
Please enter 'YES' or press <ENTER> to AGREE to the EULA:
System initialization in progress.
You must change the password for 'admin' to continue.
Enter new password: ********
Confirm new password: ********
You must configure the network to continue.
You must configure at least one of IPv4 or IPv6.
Do you want to configure IPv4? (y/n) [y]:
Do you want to configure IPv6? (y/n) [n]:
Configure IPv4 via DHCP or manually? (dhcp/manual) [manual]:
Enter an IPv4 address for the management interface [192.168.45.45]: 10.10.10.15
Enter an IPv4 netmask for the management interface [255.255.255.0]: 255.255.255.192
Enter the IPv4 default gateway for the management interface [data-interfaces]:
Enter a fully qualified hostname for this system [firepower]: ftd-1.cisco.com
Enter a comma-separated list of DNS servers or 'none' [208.67.222.222,208.67.220.220]:
Enter a comma-separated list of search domains or 'none' []:
If your networking information has changed, you will need to reconnect.
For HTTP Proxy configuration, run 'configure network http-proxy'
Manage the device locally? (yes/no) [yes]: no
Configure firewall mode? (routed/transparent) [routed]:
Configuring firewall mode ...
Update policy deployment information
- add device configuration
- add network discovery
- add system policy
You can register the sensor to a Firepower Management Center and use the
Firepower Management Center to manage it. Note that registering the sensor
to a Firepower Management Center disables on-sensor Firepower Services
management capabilities.
When registering the sensor to a Firepower Management Center, a unique
alphanumeric registration key is always required.
a sensor to a Firepower Management Center, you must provide the hostname or
the IP address along with the registration key.
Cisco Firepower 1010 Getting Started Guide
138
Please stand by.
In most cases, to register
Threat Defense Deployment with CDO
Advertisement
Chapters
Table of Contents
