Table of Contents
Advertisement
Configure Interfaces
Step 3
(Optional) Disable switch port mode for any of the switch ports (Ethernet1/2 through 1/8) by clicking the
slider in the SwitchPort column so it shows as disabled (
Step 4
Enable the switch ports.
a) Click the Edit ( ) for the switch port.
b) Enable the interface by checking the Enabled check box.
c) (Optional) Change the VLAN ID; the default is 1. You will next add a VLAN interface to match this ID.
d) Click OK.
Step 5
Add the inside VLAN interface.
a) Click Add Interfaces > VLAN Interface.
The General tab appears.
Cisco Firepower 1010 Getting Started Guide
70
Threat Defense Deployment with a Remote Management Center
).
Advertisement
Chapters
Table of Contents
