Related Manuals for Toro Recycler 22284
Summary of Contents for Toro Recycler 22284
- Page 1 Form No. 3463-300 Rev A Heavy-Duty 60V 21in Recycler ® /Rear Bagger Lawn Mower Model No. 22284—Serial No. 400000000 and Up *3463-300* Register at www.Toro.com. Original Instructions (EN)
-
Page 2: Safety-Alert Symbol
This manual uses two other words to highlight additional information, contact an Authorized Service information. Important calls attention to special Dealer or Toro Customer Service and have the model mechanical information and Note emphasizes general and serial numbers of your product ready. -
Page 3: Table Of Contents
Replace any damaged or unreadable labels. Use only the battery pack specified by Toro. Using other accessories and attachments may increase the risk of injury and fire. Plugging the battery charger into an outlet that is... - Page 4 Charge the battery pack with only the battery the influence of alcohol or drugs. charger specified by Toro. A charger suitable for Do not use a battery-operated lawn mower in 1 type of battery pack may create a risk of fire rain.
- Page 5 Replace the battery pack with a genuine Sharpen a dull blade on both edges to maintain Toro battery pack only; using another type of balance. Clean the blade and ensure that it is battery pack may cause a fire or risk of injury.
-
Page 6: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal133-8054 133-8054 decal94-8072 94-8072 decal134-4691 134-4691 1. Auto speed 2. - Page 7 Model 66810 decal140-8471 140-8471 decal145-8260 145-8260 1. Read the Operator’s 3. Do not expose to rain. Manual. 2. Keep away from open fire or flames. decal145-8265 145-8265 decal144-3175 1. Battery charge status 144-3175 1. Read the Operator’s 3. To shut off the machine, Manual.
- Page 8 decal116-7583 116-7583 1. Warning—read the Operator’s Manual; do not operate this 4. Cutting/dismemberment hazard of hand or foot, mower machine unless you are trained. blade—stay away from moving parts; keep all guards in place. 2. Thrown object hazard—keep bystanders away. 5.
-
Page 9: Setup
Setup Mount it indoors (such as a garage or other dry place), near a power outlet, and out of the reach of children. Refer to Figure 3 for assistance in mounting the Important: Remove and discard the protective charger. plastic sheet that covers the motor and any other plastic or wrapping on the machine. -
Page 10: Installing The Handle
Installing the Handle No Parts Required Procedure g351011 Figure 5... -
Page 11: Installing The Cable Guard
Installing the Cable Guard No Parts Required Procedure g350107 Figure 6 Assembling the Grass Bag No Parts Required Procedure g238450 Figure 7... -
Page 12: Adjusting The Self-Propel Drive
Product Overview Adjusting the Self-Propel Drive No Parts Required Procedure Important: You must adjust the self-propel-drive cable before you operate the machine for the first time. Refer to Adjusting the Self-Propel Drive (page 23). g341670 Figure 8 1. Handle 6. Wheel-drive-control knob (not shown) 2. -
Page 13: Specifications
Contact your Authorized Service Dealer or authorized Toro distributor or go to www.Toro.com for a list of all approved attachments and accessories. To ensure optimum performance and continued safety certification of the machine, use only genuine Toro replacement parts and accessories. -
Page 14: Before Operation
Operation Before Operation Installing the Battery Pack Important: Use the battery pack only in temperatures that are within the appropriate range; refer Specifications (page 13). Make sure that the vents on the battery are clear of any dust and debris. Lift up the battery-compartment lid (A of Figure 10). -
Page 15: Adjusting The Cutting Height
Adjusting the Cutting Height WARNING Adjusting the height-of-cut could bring your hands into contact with a moving blade and result in serious injury. • Shut off the motor, remove the battery, and wait for all moving parts to stop before adjusting the cutting height. -
Page 16: Adjusting The Handle Height
Adjusting the Handle Height You can raise or lower the handle in 1 of 3 positions that is more comfortable for you (Figure 12). g331956 Figure 12 Remove both handle bolts and corresponding nuts. Move the handle to the desired height position. Secure the handle with the previously removed bolts and corresponding nuts. -
Page 17: Operating The Self-Propel Drive
Operating the Self-Propel Adjusting the Blade Speed Drive This machine has 2 blade-speed settings: A • To engage the self-propel-drive: Move the • In the A position, the blade speed adjusts self-propel-drive lever to the desired ground speed automatically for greater efficiency. The machine and pull the self-propel-drive bar to the handle and detects changes in the cutting conditions and hold it... -
Page 18: Recycling The Clippings
A worn grass bag could allow small stones and other similar debris to be thrown toward you or bystanders, resulting in serious personal injury or death. Check the grass bag frequently. If it is damaged, install a new Toro replacement bag. WARNING The blades are sharp;... - Page 19 Removing the Grass Bag DANGER The machine can throw grass clippings and other objects through an opening in the machine housing. Objects thrown with enough force could cause serious personal injury or death to you or to bystanders. • Never remove the grass bag and then start the machine without the discharge plug installed on the machine.
-
Page 20: Shutting Off The Machine
Note: Whenever you are not using the machine, remove the battery pack. • Replace the blade when necessary with a Toro replacement blade. Cutting Grass • Grass grows at different rates at different times of the year. In the summer heat, it is best to cut grass at the 64 mm (2-1/2 inch), 76 mm (3 inch), or 89 mm (3-1/2 inch) cutting-height settings. -
Page 21: After Operation
Cutting Leaves Slide the battery pack into the charger until it is fully seated (Figure 18). • After cutting the lawn, ensure that half of the lawn shows through the cut leaf cover. You may need To remove the battery pack, slide the battery to make more than a single pass over the leaves. -
Page 22: Cleaning Under The Machine
Cleaning under the Machine Service Interval: After each use To ensure the best performance, keep the underside of the machine clean and clean under the machine g002600 soon after you have completed mowing. Be especially Figure 20 careful to keep the kickers free of debris (Figure 19). -
Page 23: Maintenance
Maintenance additional turn to allow for the normal stretching of the belt during the break-in period. Note: You can skip this step if you are adjusting Adjusting the Self-Propel a used belt. Drive Maintaining the Blade If the machine is new, does not self-propel, or it tends to creep forward, adjust the drive cable. - Page 24 Inspecting the Blade Service Interval: Before each use or daily—Inspect the mower blades for wear or damage. Carefully examine the blade for sharpness and wear, especially where the flat and the curved parts meet (Figure 23A). Because sand and abrasive material g027496 Figure 24 can wear away the metal that connects the flat and...
-
Page 25: Cleaning Under The Belt Cover
Installing the Blade Install a sharp, balanced Toro blade, the accelerator, the lock washer, and the blade bolt. The sail of the blade must point toward the top of the mower housing for proper installation. -
Page 26: Cleaning The Wheels
Touch up all rusted or chipped paint surfaces information on how to responsibly recycle the with paint available from an Authorized Service battery. If you are located outside of the US Dealer. and Canada, please contact your authorized Toro distributor. -
Page 27: Troubleshooting
Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem Possible Cause Corrective Action The machine does not start. - Page 28 Problem Possible Cause Corrective Action The LED indicator light on the battery 1. There is an error in the communication 1. Remove the battery pack from the charger is blinking red. between the battery pack and the battery charger, unplug the battery charger.
- Page 29 Notes:...
- Page 30 Notes:...
- Page 31 While the exposure from Toro products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Toro has elected to provide the Prop 65 warnings. Moreover, if Toro does not provide these warnings, it could be sued by the State of California or by private parties seeking to enforce Prop 65 and subject to substantial penalties.