Altitude Requirements; Dust And Particulate Requirements; Minimizing Electromagnetic And Radio Frequency Interference - Cisco Nexus 9396TX Installation Manual

Aci-mode switch

Hide thumbs Also See for Nexus 9396TX:

Table of Contents

Altitude Requirements

Altitude rating is based on power supply installed; see critical components list in the system CB report for

altitude rating.

Exhaust fans cool power supplies and system fans cool switches by drawing in air and exhausting air out

through various openings in the chassis. However, fans also ingest dust and other particles, causing contaminant

buildup in the switch and increased internal chassis temperature. Dust and particles can act as insulators and

interfere with the mechanical components in the switch. A clean operating environment can greatly reduce

the negative effects of dust and other particles.

In addition to keeping your environment free of dust and particles, follow these precautions to avoid

contamination of your switch:

• Do not permit smoking near the switch.

• Do not permit food or drink near the switch.

Electromagnetic interference (EMI) and radio frequency interference (RFI) from the switch can adversely

affect other devices, such as radio and television (TV) receivers. Radio frequencies that emanate from the

switch can also interfere with cordless and low-power telephones. Conversely, RFI from high-power telephones

can cause spurious characters to appear on the switch monitor.

RFI is defined as any EMI with a frequency above 10 kHz. This type of interference can travel from the switch

to other devices through the power cable and power source or through the air as transmitted radio waves. The

Federal Communications Commission (FCC) publishes specific regulations to limit the amount of EMI and

RFI that are emitted by computing equipment. Each switch meets these FCC regulations.

To reduce the possibility of EMI and RFI, follow these guidelines:

• Cover all open expansion slots with a blank filler plate.

• Always use shielded cables with metal connector shells for attaching peripherals to the switch.

When wires are run for any significant distance in an electromagnetic field, interference can occur to the

signals on the wires with the following implications:

• Bad wiring can result in radio interference emanating from the plant wiring.

• Strong EMI, especially when it is caused by lightning or radio transmitters, can destroy the signal drivers

Note

Cisco Nexus 9396TX ACI-Mode Switch Hardware Installation Guide

and receivers in the chassis and even create an electrical hazard by conducting power surges through

lines into equipment.

To predict and prevent strong EMI, you need to consult experts in radio frequency interference (RFI).

Preparing the Site

Table of Contents