Table of Contents
Advertisement
Filters and maintenance
Activated carbon filter:
For binding odours in recirculating air
mode.
Fitting and removal:
1.
Open door to the stop.
2. Push the filter screen
up slightly, lift it
towards you over the
brackets and take it
out downwards.
3. Insert the screw through the wing nut
and bushing and screw into the housing
(only necessary upon initial fitting. The
screw and wing nut are included with
activated carbon filter.
4. Using a screwdriver or similar, press the
two lugs in the housing through to the
back (only necessary upon initial fitting).
8
5. Insert activated carbon filter in the lower
left corner of the housing. Shift it until
both hooks slot into the holes and then
secure in place with the wing nut.
6. Position the filter
screen against the
housing and push
upwards. Push in
the lower edge
over the brackets
and lower the
screen into place.
Check that the filter screen is securely
located behind the retaining brackets on
both sides.
Removal is in the reverse sequence.
Replacing the activated carbon filter:
During normal operation (daily 1 to 2
hours) the activated carbon filter must
be replaced approximately 1x year.
The activated carbon filter can be
purchased FROM YOUR DEALER (see
Optional accessories).
Only use original filters.
These ensure optimum function.
Disposal of the old activated carbon filter:
Activated carbon filters do not contain
any harmful substances. They can be
disposed of as residual waste.
2.
1.
1.
2.
Advertisement
Table of Contents
