Assembly; Fitting The Loop Handle; Fitting The Trimmer Guard And Trimmer Head - Husqvarna 122C Operator's Manual
Hide thumbs
Also See for 122C:
- Operator's manual (640 pages) ,
- Workshop manual (60 pages) ,
- Operator's manual (76 pages)
Table of Contents
Advertisement
Fitting the loop handle
•
Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
•
Fit the bolt, securing plate and wing nut as shown in
the diagram. Tighten the wing nut.
Fitting the trimmer guard and
trimmer head
(122LK)
•
Fit the correct trimmer guard (A) for use with the
trimmer head. Hook the trimmer guard/combination
guard onto the fitting on the shaft and secure with the
bolt (L).
•
Fit the drive disc (B) on the output shaft.
•
Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
ASSEMBLY
•
Screw on the trimmer head (H) in the opposite
direction to the direction of rotation.
•
To dismantle, follow the instructions in the reverse
order.
Fitting the trimmer guard and
trimmer head
(122C)
•
Fit the guard as shown in the diagram. Tighten
securely.
•
Fit the dust cup on the shaft. The nut must be
completely covered by the dust cup.
•
Hold the dust cup with a spanner to prevent the shaft
from rotating.
•
Screw the trimmer head onto the shaft.
–
English
11
Advertisement
Table of Contents
