Toro 144-2512 Installation Instructions

Snow thrower power kit for tx 427 and tx 525

Download this manual

TX 427 and TX 525 Snow Thrower Power Kit

Compact Tool Carrier

Model No. 144-2512

Installation

Preparing the Machine

Park the machine on a level surface.

Lower the loader arms.

Shut off the engine and remove the key.

Open the hood and secure it with the prop rod.

Removing the Fuse Panel

TX 525 Only

Pull the hairpin cotter from the bottom end of the

hood prop-rod and slide the prop rod out of the

retaining brackets and the prop-rod tab.

1. Prop-rod tab

2. Retaining bracket—top

3. Prop rod

8111 Lyndale Avenue South

Bloomington, MN 55420

Figure 1

4. Retaining

bracket—bottom

5. Hairpin cotter

Remove the 4 screws securing the fuse panel

and then pull the panel out and up to remove it.

1. Fuse panel

g004984

Original Instructions (EN)

Form No. 3441-209 Rev B

Installation Instructions

Figure 2

2. Screw

*3441-209*

Printed in the USA

g004985

Page 1 Form No. 3441-209 Rev B TX 427 and TX 525 Snow Thrower Power Kit Compact Tool Carrier Model No. 144-2512 Installation Instructions Installation Remove the 4 screws securing the fuse panel and then pull the panel out and up to remove it.
Page 2 Installing the 12 V Receptacle WARNING Using a drill without proper eye protection may allow debris to enter the eye, causing injury. When drilling or carrying out other operation, always wear eye protection. Mark and drill a hole (1-5/32 inch diameter) into the control in the location shown in Figure 3 Figure Note:...
Page 3 Installing the Wire Harnesses g333594 Figure 6 1. Wire harness installed on TX 427 2. Wire harness installed on TX 525 Install the post connectors from the port wire harness to the posts on the 12 V receptacle. g331130 Figure 8 1.