Installation - Siemens UROSKOP ACCESS Installation And Startup
Urodynamic interface/scan converter
Hide thumbs
Also See for UROSKOP ACCESS:
- Troubleshooting manual (26 pages) ,
- Instructions manual (18 pages)
Table of Contents
Advertisement
8
Installation
•
Remove the rear panel, the cover, and the right side panel (as viewed from the front of
the container) from the imaging system container (see also the document "Installation
Instructions; System" [SPL5-330.812.01]).
•
Install the scan converter
amplifier) in the imaging system container of the UROSKOP Access.
- No OTV is installed if an endoscopic interface is present.
Fig. 1:
Pos. 1
Pos. 2
Pos. 3
Pos. 4
Pos. 5
UROSKOP ACCESS
(3/Fig. 1 / p. 8)
Imaging system container
Image signal splitter 2 (reference image)
Image signal splitter (live image)
Scan converter
Optical isolation amplifier (OTV)
Scan converter holder
SPL5-330.814.01.05.02
08.05
Urodynamic interface
und den OTV
(4/Fig. 1 / p. 8)
Page 8 of 18
CS PS 24
0
(optical isolation
Siemens AG
Medical Solutions
Advertisement
Table of Contents
