Table of Contents
Advertisement
• Before you touch the Start/Pauze - Départ/
Pause
button: the appliance cannot
start.
The appliance keeps the selection of this
option after you switch it off.
10.3 Permanent Extra Rinse
With this option you can permanently have an
extra rinse when you set a new programme.
To activate/deactivate this option, hold the
Extra
button pressed for 3 seconds until
the indicator
comes on/goes off on the
display.
When it is activated, the appliance will default
to this option after you switch it off or change/
reset the programme.
This option increases the programme
duration.
10.4 Operating Hours Counter
It is possible to visualise the total operating
time of the appliance in hours, starting from
the first switching on. This value will count
operating time of the cycles (does not include
pauses, delayed start time). To visualise this
value, proceed as follows:
1. Switch the appliance on by pressing
Aan/Uit - Marche/Arrêt
2. Turn the programme knob to the first
position.
3. Press and hold the Vlekken/Voorw. -
Taches/Prélav.
some seconds (within 10 seconds after
the switching on. After these 10 seconds,
the key combination activates and
deactivates the acoustic signals).
11. BEFORE FIRST USE
1. Make sure that all transit bolts have been
removed from the appliance.
2. Make sure that the electrical power is
available and the water tap is open.
3. Pour a small quantity of detergent into the
compartment marked
22
ENGLISH
button.
and Pods® buttons for
.
4. After 3 seconds the total hours operated
by the appliance are shown in the display:
e.g. 1276 hours, the display shows the
text Hr for 2 seconds, 12 (thousands and
hundreds) for 2 seconds and 76 (tens and
units).
If the procedure does not work (due to
timeout, wrong programme dial position
or wrong keys combination), switch the
appliance off and repeat sequence from
the beginning.
10.5 Factory Reset
This function allows to restore the factory
default options. To activate this option follow
steps below:
1. Switch the appliance on by pressing
Aan/Uit - Marche/Arrêt
2. Turn the programme knob to any
programme.
3. Press and hold the Centrifugeren -
Essorage
and Plus Steam
some seconds (within 10 seconds after
the switching on. After these 10 seconds,
the key combination activates and
deactivates the acoustic signals).
4. The display will show
seconds.
If the procedure does not work (due to
timeout, wrong programme dial position
or wrong keys combination), switch the
appliance off and repeat sequence from
the beginning.
4. Set and start a programme for cotton at
the highest temperature without any
laundry in the drum.
This removes all possible dirt from the drum
and the tub.
button.
buttons for
for about 5
Advertisement
Table of Contents
